Electronics Forum | Thu Oct 20 23:19:09 EDT 2005 | Cmiller
You should not be worried about these points in the SMEMA standard. You need to make it work for your application. If you are running really small boards, keep the gap between conveyors and the lead-in as tight as you can. If you are using large pane
Electronics Forum | Sun Oct 16 04:23:20 EDT 2005 | olas
I have a couple of questions about the SMEMA conveyor (standard 1.2); I posted the question to them but had no answer. SMEMA says: 5) Maximum gap. The maximum gap between the in-line machine track ends is 0.375� I would suppose this gap refers to th
Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika
I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not
Electronics Forum | Tue Nov 30 08:01:28 EST 2010 | edmaya33
Conveyor Technologies may be the solution.We've been using this for 10 years and come up with the various sizes and configuration that suits your needs. Being a less maintenace is an added factor.
Electronics Forum | Thu Mar 23 23:21:10 EST 2006 | AR
100 cm/min) the motor runs without complaint. Too bad we run the conveyor as slowly as 10 cm/min... I'll try replacing the control board next when I get my hands on one.
Electronics Forum | Wed Jul 13 13:23:34 EDT 2011 | kkay
We have multuiple pcb transport conveyors that use the 10mm wide flat green blets on either edge. Does anyone know of a kit to purchase where we could make our own or a company that supplies different sizes? Thanks
Electronics Forum | Wed Jun 07 23:57:22 EDT 2017 | marcelll
Hi, Try to find replacement edge belt pulley for old PCT conveyor. Any idea where to find a supplier to buy small pulley for 1/4 inch edge belt ? Thanks
Electronics Forum | Thu Dec 07 15:23:21 EST 2017 | emeto
Is that a 3 stage conveyor or a single stage? If it is a single stage, your sensor doesn't work, because your motor is already turning. If the input stage is separate you have two options - sensor or motor. Just check them both for proper functioning
Electronics Forum | Thu Mar 23 07:55:10 EST 2006 | Peter
We had the problem for � a year, and cleaned everything. We replaced the DART-control unit, and have not seen the problem since
Electronics Forum | Thu Aug 13 19:46:23 EDT 2020 | kojotssss
DEK horizon: Green belt PN:165520; Black belt PN:181706. 3mmx2450mm Solid ESD