Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Thu Jan 11 05:58:35 EST 2007 | Peter
Hi All, We again have problem with Zevatech FS-730 This machine shows error E202162: "System error: T axis of center head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low spe
Electronics Forum | Mon Apr 11 15:57:25 EDT 2011 | bobpan
If the feeders that you are having problems with have tall parts in them.....and these are the ones the machine is stopping on.....check to see that you are not scanning higher than what your function 30 nozzle height is. In other words...if your fun
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Fri Sep 17 09:25:12 EDT 1999 | Eyal Dickerman
| Hi All, | | I am running 19 Siemens S20 Machine here. I found out that the Siemens Machine once a while hangs. The remedy is reboot the machine. I wonder what is the machine hang rate for other S20 machine else where. | | Can anyone give me any s
Electronics Forum | Thu Mar 30 14:00:32 EST 2006 | jdengler
Hi Bert, There should be an action occuring when the machine hangs-up(ie: Q motor rotating, getting ready to change nozzle, or other action). See if you can find this. The first thing that comes to mind is a loss of the signal for a nozzle in the
Electronics Forum | Sun Aug 21 15:35:22 EDT 2022 | zadir
good afternoon, please tell me, maybe someone has encountered a problem on the juki 730/740 machine.we have a 24 volt 10 amp power supply broken on it (it stopped turning on completely) we changed it, but now stanou can't find the zero point, he come
Electronics Forum | Thu Aug 26 22:10:43 EDT 2004 | KEN
I work for a CM that is a principle PCBA supplier for Cognex. We have not seen these legacy systems in many, many years. However, the cognex 8000, IS1000, IS2000 systems are still running strong in many OEM vision applications (especially recently
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Mon Feb 20 14:56:22 EST 2012 | acsscott
Ok, so we figured out that if the LCS is connected, we don't get the error. So, the HDLC data buss gos out and back, or is terminated in the LCS. How to remove the LCS? We try to go into maintenance screen to change the machine configuration, and
