Electronics Forum | Fri Mar 19 13:18:03 EDT 2010 | deanm
Regarding your question about buying equipment to vacuum seal the MBBs, according to the IPC/JEDEC standard, "Full air evacuation is not needed or recommended; light air evacuation will reduce the packaging bulk and enhance carton packing. Excessive
Electronics Forum | Tue Mar 23 03:42:51 EDT 2010 | grahamcooper22
Hi, It is very important to follow IPC JEDEC 33 specification for storage and handing of all MSDs. In many instances defects caused by excess moisture in packages is not immediately evident (pcbs may pass final test) but when pcb has been in the fiel
Electronics Forum | Wed May 15 05:44:04 EDT 2019 | peterchan
1、YSVJ-650B three-group multi- blades cutting machine, multiple sets of tools run at the same time, split the whole piece at one time, greatly improve production efficiency; multiple sets of tool design ensure that the split plate effect is not defor
Electronics Forum | Fri Aug 28 12:11:10 EDT 2015 | davef
LED: [Light-emitting diode] https://en.wikipedia.org/wiki/Light-emitting_diode Neon lamp: https://en.wikipedia.org/wiki/Neon_lamp
Electronics Forum | Tue Dec 22 23:57:21 EST 2020 | ttheis
Ok; is this the 5a box located under and behind the pdp? I see now in the diagram it is labeled pdp1.ps1. Any suggestion for what to check to determine if the problem is the power supply or something connected to it? I noticed that when the 12v po
Electronics Forum | Tue Dec 22 00:11:41 EST 2020 | ttheis
Well it seems you are onto something with the vme power supply. The issue has resurfaced and I did notice the LED's on the keyboard went out when the issue occurs. I looked at the power distribution board to the left of the vme and it shows the +12V
Electronics Forum | Thu May 01 23:32:46 EDT 2014 | asajedi
I have assembled panels of 24"X9.5" LED Panels (24 strips of 10mm). I need to cut them into strips and join them together then add double sided 3M tape and spool them. How is this best accomplished. Laser Cutting, Die Cutting, Roller Cutting
Electronics Forum | Tue May 28 18:31:08 EDT 2019 | jlawson
Solder paste flux is main contributor, Lead termination chemical-oxide by products and PCB Plating-Chemicals. Reflow profile would have very limited if not no impact really unless is way off. Paste volume control and Stencil design plays a big part
Electronics Forum | Thu Oct 11 23:18:50 EDT 2012 | burdra
I want to purchase bulk LED lights. Need a reliable and affordable supplier. Thanks
Electronics Forum | Fri Oct 12 11:18:04 EDT 2012 | capse
company with LED light expertise; http://www.lunaraccents.com/
