Electronics Forum | Wed Dec 04 12:57:01 EST 2013 | markhoch
Thank you for your reply Chris We have the same exact unit. But we've had issues with the cleaning solution leaching into the electrical cabinet and shorting out the PLC. They use a foam weather strip as the only insulation, and the cleaning solutio
Electronics Forum | Thu Feb 06 14:06:09 EST 2014 | rgduval
If you get a response to this, I might have a need to look into something similar. Though, I don't need adhesive..I need something more like kapton or masking dots. I am working on a new job that requires conformal coating, and LEDs that need to be
Electronics Forum | Thu Oct 23 09:48:15 EDT 2014 | rgduval
We tried various products years ago to no avail. As you noted, labels either survived reflow or wash, but, rarely, both. We had one that was made out of kapton, and no more than .125" wide that survived more than the others...but, I don't recall an
Electronics Forum | Wed Mar 04 10:23:03 EST 2015 | rgduval
I haven't used this particular CC, but...found this in their data sheet: "AVR 80 BA Conformal Coating will be touch dry after 15 - 20 minutes at room temperature and does not require a thermal cure. The full properties of the coating will be obtaine
Electronics Forum | Wed Mar 25 15:12:14 EDT 2015 | marcelorotofrance
Hi, Bob you're right. I replaced the Z-rod and the machine started to go alright. When I examined the head's mechanism I omitted to check the most exposed an delicate part... my bad. The old Z-rod came with the machine, and its slide movement was loc
Electronics Forum | Fri Dec 18 12:25:40 EST 2015 | deanm
We are required by AS9100 to keep expired material/chemicals off the floor. Examples include solder paste, flux, adhesives, conformal coating, etc. We have a system in place to prevent such occurrences but once in a while something is not accounted f
Electronics Forum | Tue Jul 05 18:24:50 EDT 2016 | padawanlinuxero
Hi have you try to use some type of adhesive like loctite or a solder mask to avoid lifted components, we use both in 2 different products, we use loctite to avoid a hall inserted in a plastic carrier, lift when being solder in the solder wave, the s
Electronics Forum | Thu Sep 08 12:37:55 EDT 2016 | mmjm_1099
We stated placing labels on our lines for a couple years now and over the past year it has really taken off. Hover-Davis is the place you need to contact in order to get the correct feeder for your machines. They will want a single column label with
Electronics Forum | Wed Feb 01 11:33:37 EST 2017 | emeto
Joshua, 100um is 4mil aperture. You should ask several stencil houses about the possibility to print that small amount of paste(type 6 paste is available now with very small solder spheres 5-15um diameter). Even applying small amount(thin layer of f
Electronics Forum | Wed Oct 04 00:47:57 EDT 2017 | silversurfer11
Hello, I am experiencing a high pitched noise coming from a computer component and I think it might be the 18 inductors they have placed on the PCB as part of the VRM. I am think of using a 2 part Thermal Conductive Adhesive and fix all the inducto
