Electronics Forum | Fri Mar 08 15:23:15 EST 2024 | tommy_magyar
They have a software called JaNets to do that. I only briefly worked for a couple of months with Juki, but JaNets did what you are asking for. Most likely you will need licence from Juki for that. Regards, Tom
Electronics Forum | Mon Mar 11 14:36:05 EDT 2024 | jergod
Thank you! Parmi is on my list because it has close support and service but i have been also hearing some bad user experiences from it. Koh Young seems to be really good option, only bad thing i have heard about it has been software bugs but maybe
Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Thu Mar 28 18:00:31 EDT 2024 | alexv
The tapping noise is what you hear when Hydra taps each tool on the tool bank to make sure the tips are seated well. The error is a Z-motor problem. The gear is at the top of the Hydra and needs grease. Have you cleaned the old grease and applied new
Electronics Forum | Wed Apr 03 22:07:13 EDT 2024 | compit
Not every program can clone a CF card. I did it but I need to check with what kind. You can also simply insert a new CF card into the machine, INSTALL DOS from floppy disks (same version) and then COPY the entire disk EXCEPT the system files (msdos.s
Electronics Forum | Wed Apr 17 02:13:22 EDT 2024 | acouto
Good morning, After the visit of an external technician due to the change of cables, when resetting the camera mark again when doing the inspection fails to check the calibration points of the conveyor. Is it possible that the technician has decalibr
Electronics Forum | Tue Apr 23 15:19:35 EDT 2024 | tey422
The impact of course is a lot less for newer PnP, but for older machine there might be different story. What if the bad marks not being read correctly? The result would be "good" board being skipped, while "X-out" being loaded. That would waste mu
Electronics Forum | Tue Dec 05 19:15:41 EST 2000 | Michael Parker
Kel- My first impulse is to tell you to go ahead and try it your way. We all need to learn from our mistakes to find the right way. What you are proposing is called a "smoke" test. As long as you can keep the smoke inside the device, in your case th
Electronics Forum | Thu Jul 13 05:23:30 EDT 2000 | Donnie
There a few questions that I have for you. 1. What type of flux are you using? 2. What temps are your preheaters set at? 3. Can you possibly place them on after the wave? The reason I'm asking is that there may be some adjustments to the wave to bur
Electronics Forum | Thu Mar 22 13:41:41 EST 2001 | mparker
What's the reality of the situation? Are you creating a specmanship issue here just to satisfy Class 3? Can you demonstrate that the paste volume applied to the plastic QFP's give sufficient overall fillets for mechanical and electrical properties? W