Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Wed Feb 06 00:43:37 EST 2008 | jmelson
Well, as usual, you can't trust ANY documentation to get it right! I have a CSM84, model PA1306/20, the last model with DC brush motors. I have the service manual for the machine, it has schematics of much of the machine, but skips the servo amps a
Electronics Forum | Tue Apr 21 12:48:13 EDT 2009 | bk
ok you verified that the motor was bad. So now i would go back and verify that your voltages are still good on the back of the computer box and on the booster board. If they all check out fine. I would take the mot x board from your working machine a
Electronics Forum | Fri Jan 10 15:33:57 EST 2014 | hans88
Hello Rob, Thanks for your fast reply. I will check the parts you mentioned. You were right about the mot card we swaped it with a new one but that made no difference. Today we tried to find were the problem could be we: - removed the j1, j2 and
Electronics Forum | Thu Feb 14 21:52:56 EST 2008 | keithej2
Thanks for the reply. The IP3 we're working on is a 4400. We installed a new motor/encoder today but it didn't help. So far we've swapped the CPU, vision card, both LSOs and the servo cards. We've been poking around the relays and wiring tonight but
Electronics Forum | Sun Jul 05 23:30:01 EDT 2009 | jeffr
A feedback error means that a particular axis did not respond by moving in a normal manner. Check the following:- 1/.. Mechanical binding. (Servo Off, then check axis moves without binding). 2/.. Check encoder plugs of that axis. Note that Philips/Ya
Electronics Forum | Mon Mar 26 17:09:48 EDT 2012 | test_tech
I have an Eclipse 1, that is no longer in production use for pick and place, but I would like to use the the gantry system and install a custom head to perform other tasks. I am looking for some guidance or information on how the existing servo con
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
