Electronics Forum | Fri Oct 22 09:44:42 EDT 1999 | John Bashe
The CCGA package is difficult to handle and automate in the assembly process. The leads can be fragile, and vision recognition of the package and leads is difficult. Special lighting and/or a special vision algorithm will probably be needed if you wa
Electronics Forum | Mon Feb 16 01:26:30 EST 2004 | Frank
The 575 was based on the 570 machine. The 570 was Juki's first laser centered machine. It can do 0402 and ICs with a pitch of 0.65mm or greater. The 575, was a re-vamped 570 that Zevatech came up with. Juki played no part in the 575. Zevatech ad
Electronics Forum | Thu Apr 15 14:29:09 EDT 2004 | Debi
What are diffrerences between DEK 248 and MPM Microflex? We are thinking about off-line screen printer with vision and wiper. When i compare specification MPM has better accurancy 12,5um and DEK 248 25um so one point for MPM. MPM is a new constructio
Electronics Forum | Tue Nov 10 17:23:51 EST 2009 | gregcr
GSM's are only 500 to register with UIC. There are a ton of GSMI's around. We have always run chipshooters with GSM's and now the new Advantis machines from UIC. GSM's are very accurate, but a bit of a pain if your running lots of chips (thus we r
Electronics Forum | Fri Aug 22 02:10:55 EDT 2014 | mdang
I wonder if anyone can help me with this problem. My FUJI CP65 with 0201 camera is working fine for a while. Now, it starts losing the vision on 0201 camera. The system will run for a while then I don't see the part on the part monitor when the nozzl
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Tue May 05 14:57:48 EDT 2020 | greezmky
I will have to check the nozzles to see if they are stuck up, but I don't believe so as I changed them all out a couple weeks ago. I have not went back to the feeder yet because I am not getting vision errors. I was able to see the diodes fly off on
Electronics Forum | Wed Nov 12 06:23:09 EST 2008 | griffin
One thing to consider regarding the capacitor, The leads are not 100% straight beneath the plastic bottom part. And if you align with regards to the two leads, the leads will be aligned to the pads of your board, but the body of the capacitor is look
Electronics Forum | Fri May 14 09:34:18 EDT 2010 | lockj69w
This procedure is from UIC's knowledge base. TO run Diagnostics on AISI 3500 vision. Use of this procedure will require reloading of vision executive once complete. 1. verify PC1 COMM2 is connected to COMM2 on the RADISYS board in slot 1 of VME chass
Electronics Forum | Mon Sep 20 14:46:03 EDT 1999 | Dave F
| Hi all, | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are TH, the S
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723