Electronics Forum | Tue Mar 07 10:43:27 EST 2006 | dougs
The E has a different x-y table setup, i seem to remember the CP6 having rollers and cams to control the z table height, the CP6E has a belt driven z axis. Also i think the CP6E is slightly faster, 44K cph against 40K, still just program it as a CP6
Electronics Forum | Tue Mar 07 08:44:10 EST 2006 | billyd
Craig - You should not use the leaded parts, as you are, in all likelyhood, going to see massive voiding. We just went through this same deal where I work, because a manufacturer sent us the incorrect parts. You can go with lead free parts with regul
Electronics Forum | Tue Mar 07 10:06:29 EST 2006 | pjc
Can't measure, but there is a dot inspection capability with the 401 auto-vision option that you should have on your Gemini. Check the manual or call Speedline Tech support for instructions, 800-737-8110. This option allows you to teach a "golden dot
Electronics Forum | Tue Mar 07 10:45:28 EST 2006 | Rob
Hi Grant, Our parent company is a distributor - if you e-mail me off line (via SMTnet)I'll look up some parts for you & let you know if/how much you're being overcharged, & if so point you in the direction of a decent distributor in whatever part of
Electronics Forum | Wed Mar 08 22:10:26 EST 2006 | pmperreca
Grant, let me suggest Nationwide Electronics, Inc. they are in palmetto,florida....941-341-9244 they are a independent distributor with ties to alot of different manufacturers. Ask for Dave or John. They will meet or beat most prices..if you give the
Electronics Forum | Wed Mar 08 10:46:40 EST 2006 | Chunks
Don't forget to buy the "Lead free heelstraps, smocks, wriststraps, hairnets and repair table" too. They cost twice as much, but you have to have them! We use regular wick and it works well with the LF solder. Vendor even ageed there was no need t
Electronics Forum | Fri Mar 10 19:22:32 EST 2006 | bman
I hate to ask an obvious question, but are you sure all of your thermocouples are attached properly? I just can't imagine a 3X5 board having such a large Delta T unless it has some really odd parts on it. You sound like you know what you're doing,
Electronics Forum | Fri Mar 17 14:53:08 EST 2006 | Board House
Hi Brad, Being that I work for a board house here is my take on this issue. In the past it used to be 1 scrap per palt up to 10% of the total order. scrap is supposed to be sepperated to location and packaged sepertaly. Then it turned into No Scra
Electronics Forum | Thu Mar 16 10:15:55 EST 2006 | slthomas
I would again suggest that you REALLY need to profile that board. It does sound like you're not getting enough heat to that component, but if you just crank up your reflow zone how will you know you're not overheating something smaller unless you b
Electronics Forum | Wed Mar 15 10:16:30 EST 2006 | John
I'm looking for an oven manufacturer that makes an oven in the 70 to 85C temperature range. I don't need 260C and all the mass/weight that comes with it. The incubator type seem to max out at 50C. Can anybody recommend a source? We're looking to bu