Electronics Forum | Thu Dec 21 11:55:31 EST 2006 | realchunks
I have one form a year 2006. Uses the studds to keep track of revolutions. Four wires going to the motor.
Electronics Forum | Thu Dec 21 11:58:07 EST 2006 | Brandon
Can you send a digital pic to bgoodwin@pentechassembly.com please? Does it turn clockwise when powered on?
Electronics Forum | Fri Dec 22 05:48:29 EST 2006 | maxinorper
Hi, We have refurbished blowers. Cleaned them, changed bearings, capacitor. These parts are standard parts, you will find them in "any" hardware store and Radio Shack type dealers.
Electronics Forum | Fri Dec 22 11:21:50 EST 2006 | Jav Thug
pls share the photo with all. I would like to formulate a pie-chart on motor revolution
Electronics Forum | Mon Oct 08 14:56:10 EDT 2001 | Mike
I think the problem is going to be the cooling zone location. All of the heat zones are built the same, but the cooling zone can not be moved easily.
Electronics Forum | Mon Sep 25 13:54:28 EDT 2017 | emeto
Check your exhaust points and cooling zones. Cooling zones should have filters that need to be cleaned and it is most probably where your problem comes from. In front(if you have two exhaust pipes) you might need a filter change as well.
Electronics Forum | Tue Dec 12 01:52:05 EST 2006 | hemu_me
As we have vitronics oven(SMR610A) made in dec,1997,which has 5 heating zones and 2 cooling zones. For Lead free soldering what should be our baseline for low/medium boards.we have gathered profiles from various paste manufacturers,however we don't k
Electronics Forum | Fri May 21 15:53:01 EDT 2021 | emeto
You should clean your cooling zones.
Electronics Forum | Fri Jun 09 13:31:33 EDT 2006 | Chunks
I believe this is a MELF, correct? If so, it could be your pad design. Most use a "horse shoe" style that seems to work well. Another thing to look at is your cooling zones. I've seen these parts remain liquidous into the cooling zone where they
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
