Electronics Forum | Wed Dec 09 05:01:33 EST 2015 | luki
Hello, I am a new user of the machine CSM84VZ III and learn to program. After formatting a disc machine lost all settings(I did not know that the settings are on the disc), most of which I have already set. Now I have a problem such that when I try t
Electronics Forum | Sat Feb 12 18:35:56 EST 2011 | gabriel1blue
Thank you, that works perfect!! Now I was able to set up the offset's and program the machine, but now head #1 will move to the feeder location but it will not move down to pick up the part, then it moves to the drop area, but its only happening on h
Electronics Forum | Sun Feb 13 16:28:00 EST 2011 | tpappano
Does nozzle #1 lower at all when it should pick up a part or is it just staying in the fully up position? If it does come down, but not quite far enough to contact the part, there are adjusting nuts on top of the head that set the lower limit for no
Electronics Forum | Mon Feb 14 05:58:06 EST 2011 | vinitverma
Gabe, You now need to teach the Datum position for the front feederbar and for the rear feederbar too. If I'm not mistaken the datum position for the front feederbar is position no. 21. Just put a feeder on position no. 21 and use the camera to find
Electronics Forum | Wed Feb 16 12:56:44 EST 2011 | gabriel1blue
Thank you, I have the program done and ready to run, but Im not able to get the machine to move to the mount location automatically, you say to highlight the location and press shift + P or T but how do I highlight the x,y data 1st? Or is this done o
Electronics Forum | Mon Oct 31 19:17:47 EDT 2011 | tpappano
One of my CSM84VZs sometimes insists on "error 120, No Point" and also, today when configuring for a new pcb, "error 118, divide by zero". I see nothing in the board data to suggest divide by zero problems. The "no point" error showed up when I add
Electronics Forum | Sun Oct 30 12:31:01 EST 2005 | Darek
Thanks a lot. Shortly and clearly.
Electronics Forum | Tue Aug 17 11:51:52 EDT 2010 | arek
Hi, I bought Philips CSM machines (CSM66-III and CSM84V-III). I need flopy disc with some files (MCH, VIS, FDR). I created MCH file but the machine send me an error message: BAD FORMAT DATA. Could anyone help me and send me correct files. Thanks
Electronics Forum | Wed Nov 02 00:48:05 EDT 2011 | tpappano
Thanks for the reply, all the parameters are being entered, but there is something subtle causing the error messages, likely some silly thing I'm overlooking. Hopefully someone is familiar with these error messages, because the manual hasn't been mu
Electronics Forum | Sun Feb 13 18:47:21 EST 2011 | gabriel1blue
Thank you for your fast reply, head 1 moves to the pick up location and stays up, then it moves to the dump location and moves down to drop the part, it was running before just the offsets where off (moving up and down). If I chance the head from hea