Electronics Forum | Thu Nov 06 13:34:30 EST 2003 | moncav
Hi John, Please check out http://www.grid-lok.com This is an automatic and compliant tooling system that may eliminate your need for custom tooling. Grid-lok has a rep in your region. Good luck, Charlie
Electronics Forum | Sat Feb 14 20:33:08 EST 2004 | Dean
Grid Lok is the best. http://www.grid-lok.com/ Well worth the money. Outstanding support under the pcb.
Electronics Forum | Wed Nov 17 17:27:01 EST 2004 | jimbernhard
Megan, I know that Ovation Products will send Grid-Lok's out for evaluation. They also sell used and demo systems directly. You can contact them from their website at http://www.grid-lok.com Hope this helps. Good luck with your evaluation
Electronics Forum | Fri Nov 09 15:52:47 EST 2007 | kmakiya
We have been using Grid Loks on our MPM Accuflex machines and see an offset in the print every so often. Haven't been able to isolate the problem. How bad was the misprint and how was it related to the grid loks? Thanks
Electronics Forum | Thu Feb 16 09:37:11 EST 2006 | mgillespie
hi, > > we tried to introduce form-flex a few > years back and it caused more problems than it > fixed. > > Switched back to pins and no > problems. > > It might have improved since but I > would be reluctant to get them again unless I was >
Electronics Forum | Wed Jan 24 11:22:46 EST 2007 | pr
Do you still have the vacuum plates in? If so, you can set the grid-lok up in the "fixed mode" (not sure what they call it,where it won't set for each board), then you could run without side clamps and the Vacuum should be enough to keep it from movi
Electronics Forum | Wed Jan 29 08:32:48 EST 2020 | dontfeedphils
I'm currently running Grid-Lok in my printer and have used it almost exclusively in the past. That being said, I'm looking for a solution to help correct/remove sag and warpage on PCBs that will run through our TRI SPI and AOI. I have no doubt th
Electronics Forum | Tue Jul 31 09:36:42 EDT 2001 | Cherry P.
To expand a little the question above...Can you give us the specific results of your research and development testing?
Electronics Forum | Fri Nov 12 02:25:10 EST 2004 | dorklover664
So the Grid-Loks are the best but if it was between the FormFlex or the Red-E-Sets what be the best? Megan
Electronics Forum | Thu Apr 14 13:20:29 EDT 2005 | pr
http://www.grid-lok.com/ good stuff! good luck, pr