Electronics Forum | Thu May 05 01:50:44 EDT 2016 | darby
Dear Forumites, It's been a while, but I have a question. I was recently asked to provide a scenario on capacity if we retired two older lines and replaced with a new line. My capacity figures were based on real time production over a period of six
Electronics Forum | Fri May 06 08:27:38 EDT 2016 | kahrpr
We have Samsung and havehad no problems with simultaneous pick ups with 201s 0r 402s. the feeders are durable and do not need much repair especially the sm feeders. The SME feeders have not been out as long so we will see so far so good. As with all
Electronics Forum | Thu May 19 02:04:36 EDT 2016 | jpcwg
Located in Shenzhen China, the Silicon Valley of hardware, ALLPCB.com is a company specialized and experienced in manufacturing printed circuit boards of prototyping and low volume production. Through the years thousands of business customers and eve
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Wed Sep 24 15:08:13 EDT 2003 | davef
Try: * Excelta Roto-Pic� 2000A [www.excelta.com] * Porta-Wand or Vac-Pac [www.virtual-ii.com] * PELCO� Vacuum Pick-Up System [www.tedpella.com]
Electronics Forum | Mon May 08 19:27:27 EDT 2006 | Tech
Does anyone know if you can teach feeder pick up location on 24mm. I have a 1998 Philips Topaz. Thanks
Electronics Forum | Mon Jul 19 12:57:59 EDT 2004 | Frank
Awhile back there was a thread here about needing to pick a BGA-type component that is dead-bug (ball-side up). The OP was looking for a special nozzle tip that will conform around the balls in order to pick the component. There were a few response