Electronics Forum | Wed Apr 30 07:50:34 EDT 2008 | realchunks
I've done it in the past. By-pass it and you'll be back in production. Make sure your power is off.
Electronics Forum | Wed Apr 30 11:41:55 EDT 2008 | gemengr
It back running now, after shut it off over night, it power back up,look like the heat sensor under of 4 resistors is start getting bad.But i'll by pass it, if it happen again. Thank you for your in put.
Electronics Forum | Wed Apr 30 07:03:07 EDT 2008 | gemengr
DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that lit
Electronics Forum | Wed Apr 05 08:33:36 EDT 2000 | Robert Hartmann
Can someone lead me to some articles or technical standards showing formulas/design criteria for thermal management in a BT BGA? I need to be able to dissipate about 4 Watts, and am having trouble finding information on how to calculate what our BGA
Electronics Forum | Mon Apr 13 14:48:38 EDT 2009 | bobpan
There is also a modify code that if set to 0 the quad-align will not turn on and you will have this error. It is one of the higher mod codes around 60-80......been so long i forget.... Good Luck Bob
Electronics Forum | Wed Apr 15 08:01:08 EDT 2009 | leemeyer
In the early days Quad machines were fitted with an alignment system that was purchased from a company named Cyberoptics. Quad then developed their own alignment system and called it Quadalign.
Electronics Forum | Thu Sep 12 20:55:39 EDT 2013 | marcelorotofrance
My own unit has an internal transformer also. It has multiple secondaries, and a divided primary which can be configured to the required voltage by changing jumpers. Best regards.
Electronics Forum | Tue Sep 10 08:46:10 EDT 2013 | rway
You're in the wrong forum. I doubt anyone here will have any experience with your type of issue (without researching it). Have you tried the dealer or a dealer related forum?
Electronics Forum | Mon Jan 06 11:07:20 EST 2020 | richardcargill
Ok.. ignore all the above, the X1 card has failed- nothing more. Can anyone recommend a supplier for a replacement ?
Electronics Forum | Mon Jan 06 14:02:00 EST 2020 | dman97
Have you tried to open the MINT program and re download the drivers to the cards? Sometimes the cards fail because the battery does not hold sufficient charge to keep the files intact.
