Electronics Forum | Tue Sep 17 17:55:36 EDT 2013 | dilogic
Yes, I know all that, but I am interested in some real figures from the field. That is, what percentage of mispicks do you experience on average (for large runs, of course)?
Electronics Forum | Fri Feb 11 14:11:51 EST 2000 | jseagle
To be more specific we have a single Contact 3AV that can run the board in question in 5 minutes from placing the board into the machine till the time it comes out. Volume is expected to be low initially but expected to pick up. It just doesn't fe
Electronics Forum | Mon Sep 16 13:29:37 EDT 2013 | larrygroves
a lot depends on the age and type of equipment you are using . Older equipment can have a lot of problems with smaller parts. If all is well with your feeders and machine you should expect something like 99.8 to 99.9 percent. some parts will be ident
Electronics Forum | Thu Feb 10 09:09:30 EST 2005 | russ
99% (there will always be that one that gets jacked somehow). Your old placement equipmment may affect this by dropped parts that get underneath the BGA, etc.. hopefully the placement accuracy will at least get the parts halfway on pad and they will
Electronics Forum | Fri Feb 11 02:42:17 EST 2005 | marakas
Thank you very much for your answer. We had: 1- 224 pins, size 19*19 mm, pitch 0.8 mm 4- 48 pins, size 11*7 mm, pitch 0.75 mm 1- 160 pins, size 15*15 mm, pitch 1 mm 1- 196 pins, size 15*15 mm, pitch 1 mm How many defects I should expect with th
Electronics Forum | Sat Feb 05 09:01:15 EST 2000 | Dave F
JS: The issue is not how efficiently/effectively that you can run your placement machine, probably. The issue is how efficiently you can run that part of your assembly process that is the bottleneck. Other than improving quality, optimizing any pa
Electronics Forum | Sat Feb 05 05:10:53 EST 2000 | Dean
It would be helpful to have some additional info on your line and process. Lets make some assumptions... Consider: re-tooling costs for your fab supplier. Can your supplier hold the additional tollerences for a larger panel. Can your supplier fab
Electronics Forum | Wed Jun 19 14:40:58 EDT 2024 | davidk
Hello Carl, Thank you for your comment Obviously, we are evolving and debugging our test to get the best results ("no escapes no false calls") :) and using a combination of 3D and 2D tests. With the previous AOI, we had a much higher false call rate,
Electronics Forum | Wed Jun 19 15:28:58 EDT 2024 | davidk
Hi Tom, Thank you for your comment 75% FPY is also our target, cause we gonna have the AOIs in the SMT line. So you would expect more opportunities? I didn´t notice but there are not so many components with high opportunity rate. (the average numbe
Electronics Forum | Fri Jun 07 14:05:39 EDT 2024 | davidk
I wanted to open a discussion and ask about opinion: What is a normal result of the inspection of an AOI? How many falls calls per component /opportunity is bad/normal/good? How many defects per component/opportunity is bad/normal/good? What is goo
