Electronics Forum | Mon Sep 08 09:04:41 EDT 2014 | chemers
Steve. It would be great if you could talk me through this independent motor test. Is there a good time to call? Thanks. Rebecca
Electronics Forum | Mon Sep 08 09:34:32 EDT 2014 | cflames17
Anytime before 1pm eastern time today should be good. we have Mycronic installing New My200's this week. He is do to arrive sometime after 1pm. I will be glad to be of assistance.
Electronics Forum | Tue Sep 09 17:09:44 EDT 2014 | chemers
Thank you to all. The problem was dust in the x wagon motor. We cleaned the motor out and everything works again. Rebecca
Electronics Forum | Thu Sep 11 17:18:13 EDT 2014 | tech1
You may want to check the brushes in that motor, could very well be the "dust" that you have seen.
Electronics Forum | Thu Sep 11 17:23:05 EDT 2014 | chemers
The brushes are terribly worn, but we put them back in until we got new ones. We have them and will be replacing tomorrow. Thanks.
Electronics Forum | Thu Nov 20 14:49:54 EST 2014 | joe98375
Greetings, I am looking into buying a wave solder machine for medium production of 100% through hole boards (~8.5"X12" dimension, not many layers, no high density part areas,
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Fri Jul 11 15:47:54 EDT 2008 | hegemon
We used these same type of parameters regardless of the QFN package size. We used componentes that ranged from 3x3mm to 12x12mm Same idea. The reduction in solder paste for the center pad is the key. Too much, and you wind up with no connects at the
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Fri Feb 11 14:11:51 EST 2000 | jseagle
To be more specific we have a single Contact 3AV that can run the board in question in 5 minutes from placing the board into the machine till the time it comes out. Volume is expected to be low initially but expected to pick up. It just doesn't fe