Electronics Forum | Fri Dec 09 02:26:31 EST 2005 | Alan.
Robert, power on the machine and go straight into DOS. You can do this by pressing and holding the Shift key as the machine is booting up. Run MINT. Try re-seating the cards too before you do this. Have you checked the voltages on the card batteries.
Electronics Forum | Fri Apr 14 13:41:21 EDT 2006 | cyber_wolf
I have tried it in the past and had the same problem. Just try to call them directly. Are you on an off shift or something ?
Electronics Forum | Fri Jul 21 09:11:38 EDT 2006 | Rob
You are welcome. Let us know what the problem was if you find it. Best regards, Rob.
Electronics Forum | Fri Jul 21 12:04:09 EDT 2006 | CKH
Hi Folk, recently, i have faced some issue on Components Misaligned (1 pad size way). What could have cause this issue... Thks & Warmest Rdgs CKH
Electronics Forum | Sat Jul 22 03:40:25 EDT 2006 | bvdb
I recently had the same problem and it drove me nuts. Finally discovered that I was using one fiducial twice instead of two different fiducials. Regards Bert
Electronics Forum | Wed Aug 09 14:17:49 EDT 2006 | chrisgriffin
I had a similar problem once. It turned out to be sprocket bearings. The sprocket was so hard to turn, the chain would stop a couple times per shift.
Electronics Forum | Tue Jan 09 18:17:47 EST 2007 | fordf1502004
Sorry I should have made it more clear. My operators are not identifing the parts after a job is run, all they are doing is bringing me a bag of parts at the end of a shift. By knowing the manufacture, i can look it up in our oracle system to identif
Electronics Forum | Tue Aug 12 08:34:31 EDT 2008 | rameshr
hai, in our smt process we are facing the following problem. The Case A tantalum capacitor used in our PCB assembly - during reflow process get shifted, due to which other components nearby that also found missing. what are the causes for this proble
Electronics Forum | Mon Feb 19 07:31:43 EST 2007 | jax
Check the nozzle. If these are the only two parts on the board that use a specific nozzle, it's a good place to start. The nozzle is probably not releasing well and shifting the component when trying to retract after placement...
Electronics Forum | Tue Feb 20 23:46:38 EST 2007 | Muhammad Haris
hi Jax the nozzle which i am using for these components are also used for large SOPs and other components so i cant blame my nozzles.The problem is, they always shift to some 5 degree plus but some times it place them accurately.