Electronics Forum | Mon Apr 04 08:35:08 EDT 2005 | py (france)
how to replace a qfn on a board , and how to weld it ? special stencil solder cream and as a BGA ?
Electronics Forum | Thu Apr 07 16:31:36 EDT 2005 | halal
Thanks for your answers! I will see them, and I'll write soon what I found helpful.
Electronics Forum | Wed Apr 06 11:10:47 EDT 2005 | smt_rookie
We process a double-side reflow board (10 ups). Chips and IC's on the bottom side while chips, IC's plus thru-hole connectors and IC sockets on top side (bottom side first then top side reflow). In the past, we were not encountering any soldering pro
Electronics Forum | Mon Apr 18 11:26:38 EDT 2005 | davef
Whenever we hear "gold" and "balls falling off", we think of black pad [hypercorrosion of nickel]. What does your EDX show?
Electronics Forum | Thu Apr 14 09:21:52 EDT 2005 | pr
What kind of wave are you using? Is this an old job and a new problem? Sounds like dross shorting to me, Make sure the wave is flowing over the back plate (at least when the board hits it). good luck, pr
Electronics Forum | Thu Apr 14 11:03:51 EDT 2005 | patrickbruneel
All possible causes aside, how can a dead short pass your ICT unless the connector is not probed.
Electronics Forum | Fri Apr 15 09:10:09 EDT 2005 | Dhanish
The biggest problem I am having is the X-Ray and ICT could not detect this shorts.ICT could not detect because onboard measurement shows Zero even without the Hair line shorts.With Hairline there is no difference in the impedance value for ICT to fai
Electronics Forum | Thu Apr 21 11:49:24 EDT 2005 | russ
Definitely would help when doing the search's. I always find a numerous amount of suggestions but you're right, you never know if anything worked! Russ
Electronics Forum | Thu Apr 21 12:39:10 EDT 2005 | patrickbruneel
Thanks Russ I must have caught you on a good day I'm not used to see you agree with me. Just kidding (couldn't resist)
Electronics Forum | Fri Apr 15 13:46:50 EDT 2005 | steve
They can be expensive and if your using water soluble chemistry you will have to immerse the pre-form into flux. Asking the vendor to provide flux with the pre-form I believe it would dry out prior to use.