Electronics Forum | Fri Feb 01 10:19:22 EST 2002 | cyber_wolf
Whoa! I beg to differ my friend. The cure profile is VERY critical in Adhesive curing, especially if your are screen printing. When you screen print adhesive you are leaving it exposed to the atmosphere for a period of time. SMT adhesive by nature i
Electronics Forum | Fri Sep 24 11:08:13 EDT 2004 | davef
We're not sure what you mean by temperature sensitive components. From an assembly process stand-point, every component we use is temperature sensitive to one level or another. More specifically, some of our products use polyphenylene sulfide (PPS)
Electronics Forum | Fri Aug 06 08:38:25 EDT 2004 | Bob R.
You don't mention the board surface finish, but BGA's on NiAu are prone to brittle fracture in the Sn-Ni intermetallic on the board side of the joint. You may not be able to see it visually, but it would show up in a cross-section. In-circuit test
Electronics Forum | Tue Sep 16 19:16:11 EDT 2008 | hegemon
Hello everyone! > > I'm a student of electrical > engineering currently working on a thesis for my > BSc degree. It will be about post reflow AOIs and > AXIs, and I'd kindly like to ask you for some > help with it. > > I would like to know if t
Electronics Forum | Thu Sep 23 08:47:25 EDT 2021 | majdi4
1)Though in many cases the difference between SAC305 and SAC405 was small,and not always statistically significant, it was observed that SAC405 generally outperformed SAC305 joints. Under 0°C to 100°C thermal cycling,no statistically significant
Electronics Forum | Fri Aug 27 13:07:44 EDT 2004 | C Lampron
Hello, I believe that the area's of concern are primarily component related. Some component are rated for a temp (usually 260 degrees max) for some length of time. Tant Caps come to mind as being heat sensitive. The other concern would be the inerme
Electronics Forum | Wed Nov 09 08:33:32 EST 2005 | gregp
Sounds like the vision is having trouble deciphering what is the component and what is the background. The problem is what if the plating is inconsistent (sounds like it is)? In this case with front (reflective) lighting the problem may never be so
Electronics Forum | Thu Jul 10 15:03:57 EDT 2014 | alexeis
Hi, An answer to this question is very complex. The amount of components and their type is only one parameter to determine the level of failure. Additional parameters that can influence are: 1. The density components on the card 2. Machine type and
Electronics Forum | Wed Jul 16 11:57:11 EDT 2014 | markhoch
We're a Tier 1 Automotive Supplier building, what I like to call, Peanut Butter and Jelly Boards. (High Volume, Low Complexity) Our first pass yield, using standard 1st Article Inspection and AOI is about 98-99% on any given day. Last night, for ex
Electronics Forum | Tue Aug 31 20:41:45 EDT 1999 | Dreamsniper
| | I am looking for a rule of thumb regarding the maximum ramp standard components (chip capacitors) can tolerate without failure during the reflow process. The standard seems to be 3C\second, but this figure is generally derived from the average r
