Electronics Forum | Fri Oct 11 16:17:17 EDT 2013 | scdunlap
In your experience, what is the most popular CAD > package in use today? > > Also, does anyone have > an automated and/or quick way of counting the > solder points on an assembly based on either > gerbers or CAD data? We use GCPrevue to view
Electronics Forum | Fri Nov 24 22:32:12 EST 2017 | myke03o
Some Customers normally don't share CAD data in order not to copy the design. What you can do is use the Pick and Place file then plot to the pcb paste/silkscreen layer of the gerber using software. Not sure if your universal machine can load a gerb
Electronics Forum | Mon Feb 26 08:58:01 EST 2018 | altus_group
Hi Wnb_Pemgr, I am not sure where your facility is based but I was hoping that we might be able to help with some of your issues? Hopefully we can support you with any ongoing problems you have or escalate any cases you have already made with Koh Yo
Electronics Forum | Mon Sep 23 10:45:34 EDT 2019 | slthomas
I have seen similar things happen with over etching and bridging but frankly the most common mistake that gives us grief is a failure to use the component manufacturer's recommended land pattern and/or aperture designs. As opposed to generating a n
Electronics Forum | Thu Aug 24 09:23:29 EDT 2000 | Dr. Ning-Cheng Lee
You are asking a very good question which has been an issue in the industry for a long long time. For operating at 225C, you will need a solder with melting point no lower than 270 or even 280C. HMP solder is very difficult to come by. At this stage,
Electronics Forum | Wed Dec 06 20:19:24 EST 2000 | Michael Parker
Ralph- Good thing you found this website so early on in your CM worklife. I am guessing you knew the job was dangerous when you took it. Be sure to refer back here daily, you will learn a mountain of things in a short time. The library also has a va
Electronics Forum | Sat Apr 24 04:41:56 EDT 1999 | Murray Pulman
Dear C.K We are routinely wave soldering 0603 and sot23 on subcontract, hence we get what we are given!!. Being UK based we use a Blundell cms 400 dual wave soldering machine (made in Coventry), Tecan Stencils and Loctite 3612 adhesive. You must k
Electronics Forum | Thu Jul 25 20:47:13 EDT 2002 | Dreamsniper
Thanks for that info... I found out that MPM has UP2000 HiE VP with price lower than DEK Horizon but just a bit higher or let's say relatively the same as DEK ELA...I find it hard to decide which among the 2 based on our budget capability. My budget
Electronics Forum | Mon Aug 12 18:26:05 EDT 2002 | pjc
If you are talking actual placement rate- from first fiducial read of board no. 1 to first fiducial read of board no. 2, here is the best I've ever seen based on the boards I've run: CP3- 141 seconds for 468 components per board (all rectangular chi
Electronics Forum | Fri Oct 22 11:53:53 EDT 2004 | C Lampron
Hi Christina, What would you be basing the yields off of? Is it solder defect, component placement, etc....? I have worked for a flex house for quite a few years. You are right. The Polyimide is very dimentionally unstable. (even more so on humid da