Electronics Forum | Mon Jun 01 09:29:22 EDT 2015 | tnisbet
Did you change the Z-Axis amplifier? Do you have the old black unit or the new retro(blue box)? Have you checked the rear distribution board for a bad or burnt connection? If you haver any further questions please contact george@goppm.com
Electronics Forum | Fri Oct 04 13:14:13 EDT 2019 | ddfreeze
I need to access the calibration menu, does anyone have a password for it? having issues with the z axis hardware limit. doesn't appear the card is bad. board raises to camera and goes back down???
Electronics Forum | Sat May 30 07:06:42 EDT 2015 | et1972
Hi I have a MPM3000HI printing machine with a following problem : Unable to run at high speed for z axis ,machine will stop at certain points . Have change ballscrew,nut ballscrew,motor and brake but still the same. Now run at low speed at 1 but t
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Fri Aug 11 12:45:10 EDT 2006 | mpm fan
It's been awhile but isn't there a sensor to tell the middle conveyor when it is lined up with the incoming and outgoing rails? If so that would explain why the table goes into Z axis overtravel. It still means your Y isn't working but makes it less
Electronics Forum | Tue Mar 28 19:43:49 EDT 2017 | aemery
Simon, Trying to dust off my 400 knowledge here, I can picture the 500 and 1500 better in my head. I think the 400 also has a Z axis amplifier box in the back of the machine. Remove the rear lower door and pull out the big square vacuum box. If it
Electronics Forum | Fri Mar 18 19:17:37 EST 2005 | valuems
Hello PMD Don't feel like that, we live with these MPM's. And we have over 10 years experience. Also never mess with the down stop on any MPM and you will be better off. Most of mpm's machines have a down stop of .0750 and it should never be cha
Electronics Forum | Tue Sep 26 10:22:51 EDT 2006 | SWAG
Histogram: Place standard tooling block in centernest. Jog camera over block. Jog z-axis to soft limit. Place a white card under camera. User mode to test. Turn board lamp on. From test menu, select histogram. With board lamp on and white under camer
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
