Electronics Forum | Thu Aug 16 07:40:27 EDT 2012 | bobpan
Here are a couple of things to look at. 1. Watch the machine run....and if it misses a part....make sure it doesnt blow out the next part being presented. Sometimes the air pressure is too high and the vacuum verify will blow the part out of the poc
Electronics Forum | Fri May 06 10:18:43 EDT 2011 | bobpan
Hello Doug, There is no tuning up of the cyber-unit. From the symptoms you describe......sounds like the white cable that plugs into the cyber is intermittent. Maybe you can find one somewhere and try that. The cyber unit is a closed assy. and was ma
Electronics Forum | Mon May 16 15:50:52 EDT 2011 | jimlas53
Yes, it looks like it would involve quite a bit... I guess it partly depends on finding the hardware/firmware, possibly from a donor machine. But it might not be worth the cost. At the moment I'm running all product on the first machine with Quada
Electronics Forum | Fri Feb 24 09:24:08 EST 2012 | bobpan
1. You should be running the machine from the computer and central contoller. (not the handheld or run button on machine) 2. What is the tep commands in your sequence steps....I think you need to have tep vision as the first step and tep vpass at the
Electronics Forum | Sun Jan 20 17:55:49 EST 2013 | ngineer
Mikej, I'm only running a single image, just want to correct for the slight variations in how the board seats in the transport. It's not more than a few mils off, but enough to cause an issue on fine pitch parts. I don't have any image fiducial
Electronics Forum | Mon Jan 21 08:36:23 EST 2013 | bobpan
The global or image fiducials is set under teach fiducials screen. You will get the option to turn on the one you want. You should choose one or the other depending on what you are building. You are correct for what tep hold,pass and tep vision does.
Electronics Forum | Sun Sep 30 07:39:00 EDT 2012 | saduquette
Hi bobpan, Just wanted to follow up on my problem. With a bit of reverse engineering, I was able to troubleshhot my board to a faulty trace between the EEPROM and DSP chip. Since it was an 'inner layer' trace I had no choice but to 'green wire' i
Electronics Forum | Wed Feb 11 09:29:59 EST 2015 | bobpan
A reading of 1 almost always means that there is something on the lens or possibly dust inside the unit blocking the laser and tricking the machine into thinking the nozzle is already down when it starts to step from the home 'up' position. Usually i
Electronics Forum | Tue Sep 19 18:06:05 EDT 2006 | lheiss
Does anyone know of a source for better documentation for the laser align settings? I managed to get a 1206 ceramic capacitor to measure and was working on a 1206 resistor and couldn't get it to succeed. I retried the cap and it failed again and ag
Electronics Forum | Tue Sep 19 22:55:21 EDT 2006 | darby
Hi Larry, me again. Painting the tip should do diddly because you are using laser. Your cap is probably passing because it's thicker and is just inside the range of the system set-up. Check and calibrate your nozzle alignment height settings. Input t
