Electronics Forum | Sat Dec 12 12:25:14 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Sat Dec 12 12:26:08 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Fri May 14 12:40:03 EDT 2004 | Kuru
My switch is good, I can check the switch and the two photo sensors on the input test screen. They are turning on and off.I can see it no the board too. When I start up I can see Tactile unit come down so I know pneumatics portion is good. I am still
Electronics Forum | Wed Jan 05 11:26:15 EST 2005 | cyber_wolf
Then Z MOTOR > Then select>CALIBRATE FORCE SENSOR NOTE: you must have a tool in the head when you do this.(Without the tip/spring pushed in) After this calibration the force should drop to 0 when you push in on the spring loaded tip. 2.) Replace th
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Thu Jan 10 15:32:54 EST 2008 | jdengler
A long time ago, in a place far, far away, I would test Fuji IP machines without the MFU's installed. They have a mechanical switch on the machine so it knows when a MFU is present. But what normally catches everyone is that the locking air cylin
Electronics Forum | Thu May 07 17:39:17 EDT 2009 | xinxi
Thanks Milroy!!Just want to make sure I got the correct position for the sensor. Is the sensor fixed at the exhaust tube looks like a metal pipe and plastic tube that connects to the top of the machine? So do you mean I need to clean this metal pipe?
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Wed Mar 31 09:26:26 EDT 2010 | Bobpan
Hello, There should be a page in the manual that explains the proper way of manually teaching a program. It has been too long for me to recall the exact steps. Here is some stuff that should help you. Do a function 3 on a placement and this will show
Electronics Forum | Tue Aug 03 17:45:43 EDT 2010 | swag
I used to wrench on those all the time! I really should be more help to you but it was a few years ago... A few more things to check - clean the line sensors on the back of the machine. Check to make sure you don't have a feeder that is allowing t