Electronics Forum | Fri Jan 16 16:57:14 EST 2015 | dilogic
I doubt you will be able to get satisfactory results with 0201. 0402 is another story. When doing 0402 projects, we use only electric (MP) feeders and always at the same feeder slots (feeder teach done for each of them). MPF08 nozzle works fine. Also
Electronics Forum | Wed Feb 11 10:57:48 EST 2015 | mbartel
I do a lot of prototyping, but I also do production boards. I produce 2000-5000 boards a month for an in house smt process. I feel this will increase do to the fact that our engineers are designing more with surface mount rather than through hole. S
Electronics Forum | Mon Apr 27 14:39:38 EDT 2015 | davef
Anirudh: When board fabs talk "surface finishing" they're talking about the solderability protection that you'd like on the solderable copper component mounting pads that you laid-out for each component: * Bare copper pads corrode very quickly * Corr
Electronics Forum | Tue Sep 29 11:49:02 EDT 2015 | spoiltforchoice
Typically - hand soldering as you are currently doing. Should your volume justify it you can invest in a selective soldering solution, these might take the form of a robotic arm that essentially replicates manual soldering or a solder jet similar to
Electronics Forum | Wed Feb 03 22:05:24 EST 2016 | mac5
Our company being an automotive supplier is all > about quality control, not a clean room > requiremen, This is a no clean process, all > surface mount boards and Solitec ovens. > Hopefully this answers your questions. Greg Hi Greg, Are you
Electronics Forum | Fri Apr 29 22:35:01 EDT 2016 | dekhead
Pneumatic failure is a good guess, as GSX/LT are renowned for their leaky airlines. However on this I would doubt, since the Board stop is a single throw pneumatic with a spring to retract. The return spring broken / disconnected is certainly a possi
Electronics Forum | Sat Jun 25 15:20:03 EDT 2016 | skipper6567
I have a mini/micro transformer that is mounted on a pcb inside my lowrance gps/plotter. I have removed it from the pcb. It has 5 through hole pins, 3 pins out bottom one side and 2 pins out bottom on opposite side. The transformer has yellow tape ar
Electronics Forum | Thu Aug 25 08:22:41 EDT 2016 | bobpan
If I have to guess then I would say the machine is first picking up a larger nozzle to pick up this part.....the nozzle is not seating on the z-rod correctly and causing a problem. Check to make sure the nozzle is being mounted correctly. You may als
Electronics Forum | Thu Sep 08 22:39:20 EDT 2016 | ttheis
Here's an idea; buy a pcb conveyor and design a simple label applicator to mount to it. Maybe replace the logic with your own or replace the PLC in the conveyor with your own solution. Shouldn't be much more than a few sensors and and a stepper motor
Electronics Forum | Thu Dec 15 11:28:45 EST 2016 | huske
Depends on the size of the elec cap and the nozzle set you have. But if you can pick it up, the wrinkle on the top of the cap can be a PIA. All you need to do is make sure the cap is being taken over the line-scan/hydra camera to center only (no mec
The SMTA membership is a network of professionals who build skills, share practical experience and develop solutions in electronic assembly technologies and related business operations.
Training Provider / Events Organizer / Association / Non-Profit
6600 City W Pkwy
Eden Prairie, MN USA
Phone: 952-920-7682