Electronics Forum | Mon Aug 21 04:20:49 EDT 2006 | Rob
Hi Mika, I used to work for the largest chip cap manufacturer in the world, and by far the largest problem we would see was cracking due to incorrect z height adjustment on Chipshooters. It can also cause solderballs and bad joints by displacing th
Electronics Forum | Fri Aug 25 11:29:09 EDT 2006 | mika
Thanks all for Your input. The thing is that we want to avoid to go in to the pattern program and change the height in the middle of running a board. For ex. We start a product, feeders are loaded in advance in the feeder preparation area, operator
Electronics Forum | Tue Oct 02 10:30:10 EDT 2012 | eniac
Difference in pick height from paper and embossed reel (typically) is 0.2 mm. Try to change your pick height and place height (different type of capacitors have a different height: for 100 nF 0603 and for 4.7 uF 0603 it's a big difference!). Can you
Electronics Forum | Fri Feb 22 13:17:56 EST 2008 | cyber_wolf
0201 Feeders are a different height than regular 8X2's I have put them on a surface plate and measured them with a height gauge. FYI: They make 0201C (Capacitor) and 0201R (Resistor)Again the difference between the two is height. Also it is CRITI
Electronics Forum | Sat Jan 08 06:37:44 EST 2022 | jineshjpr
Hi, Noticed that MPN--MAL215099913E3 used in one of our assembly with 22mm component height. In General 15mm height is right to set height calibration (98 % of the parts will be covered with this height dimensions except specific Connectors, Transfor
Electronics Forum | Mon Feb 21 16:06:10 EST 2005 | MR
I agree w/ JB; the package height definition is crucial. I have had problems w/ this in the past, and found that a resistor height was being used as a universal passive height for the capacitor in question. Properly defining the height fixed the pro
Electronics Forum | Thu Dec 08 22:15:46 EST 2005 | molosse21
Hi everyone, One of our customer is asking us wich one of these two components has a better resistance to vibration. Vibration can be a potential problem for them. He has the choice between a thru hole radial capacitor with near 0.400 in diameter an
Electronics Forum | Thu Aug 26 07:35:32 EDT 1999 | Robert Meston
For space contracts we have to mount chip capacitors/ resistors etc 0.1 to 0.4 mm from the pad height. This is to compenstae for the CTE differential in the substrate/component and also to ensure cleanliness. Does anyone have any new ideas on how t
Electronics Forum | Thu May 22 13:31:52 EDT 2003 | Dave
If you have a component with a height issue and want to lay is down (capacitor in this case), what are the best methods to consider? RTV, epoxy or something else?
Electronics Forum | Fri Mar 05 00:53:09 EST 2004 | alwil
I have an Electrolytic capacitor which is 17mm in diameter and is 16.7mm in height. It is presented in a reel,44mm x 24mm. I want to know if there is a suitable feeder available to place this part onto a Fuji IP3. Thanks, Alan.