Electronics Forum | Fri Jul 18 16:04:31 EDT 2014 | comatose
We had this. The anti-backlash nuts were binding. We took them apart, chased the threads with a tap and re-assembled with slightly less pre-load. Hasn't been a problem since.
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Mon Jul 21 06:18:15 EDT 2014 | digar
We had this. The anti-backlash nuts were binding. > We took them apart, chased the threads with a tap > and re-assembled with slightly less pre-load. > Hasn't been a problem since. > We had this. The anti-backlash nuts were binding. > We took t
Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils
I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width
Electronics Forum | Fri Jul 25 10:11:36 EDT 2014 | cgreiner
We also had this problem and found similar results with the anti-backlash nuts binding. We went through the process of cleaning the lead screws and the nuts which resolved the problem for about 6 months only to have it return. We learned that the
Electronics Forum | Fri Jul 25 10:13:01 EDT 2014 | cgreiner
We also had this problem and found similar results with the anti-backlash nuts binding. We went through the process of cleaning the lead screws and the nuts which resolved the problem for about 6 months only to have it return. We learned that the
Electronics Forum | Tue Oct 22 21:24:02 EDT 2019 | richgreen01
Hi All I have the above machine and every day on start up i get the failed to initiate hardware message.I have been getting around this by re initiating the motor controllers and it is good to go after this.Does anyone know the causes of the initiat
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Fri Oct 03 11:26:31 EDT 2003 | radney
We have been through several stages of this journey. We had no verification initially, migrated to two person verification (with reel initialing) and finally to electronic verification. Each of these steps has given us a dramatic improvement in our