Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Wed Aug 24 09:20:25 EDT 2016 | dekhead
Suspect comms link error from Y3 to Y1 crate. COM 2 off of CPU, depending on board. If CPU board has RS485 port it is direct to back panel of PC; if older board it only has RS232 and thus requires 232/485 converter board (internal to PC). then direct
Electronics Forum | Fri Jul 21 08:42:16 EDT 2017 | davef
Try: Mycronic Inc, 320 Newburyport Turnpike, Rowley MA 01969-2002; T: +1 978 948 6919 F: +1 978 948 6915
Electronics Forum | Tue Jul 18 15:16:40 EDT 2017 | robertbronx
Showing on screen this message: MIPR2: Fatal Error. Reloading Motor Controller M First time I connect and only have this message on screen. The manual only says; 1) SOFTWARE PROBLEM IN THE MOT-M SERVO PROGRAM. 2) THE MOT-M OR MI board is broken. Plea
Electronics Forum | Fri Jul 21 09:45:35 EDT 2017 | robertbronx
Hi, Dave Good morning, thank you for reply and the info. I find out the problem was an UNCONNECTED PLUG on the Power Supply unit. Which was probably caused when it was packed and shipped. Again, Thank you!! Regards
Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Mon May 09 19:24:53 EDT 2022 | rgduval
It's been a minute...but, does the My9 still have MOT boards in the computer cage? If so, swap the MOTz with the MOTx or MOTy, and see if the problem moves. If so, replace the motor controller board. If not, +1 on the encoder or Z-motor. Check fo
Electronics Forum | Thu Oct 20 20:21:31 EDT 2022 | smtusa
I looked into Fuji but heard some horror stories of $50k firmware upgrades to get older machines to work with latest software. ASM doesn't come off as small business friendly. Panasonic is a possibility, I prefer platforms that don't force you to p
Electronics Forum | Thu Nov 15 23:45:53 EST 2012 | jaimebc
robgd3, The Z motor can be purchased separately, however, the theta motor can't. You need to buy the whole midas head. I didn't get as far as dissembling the theta motor casing to get to the theta motor. That was my worse case scenario. We ran thou