Electronics Forum | Thu Apr 01 14:41:39 EST 2004 | azdback
Make sure that the image of the component in matches the way the actual part is on the feeder. To do this just go to your feeder status on the production screen, then click on the feeder that you want, in this case the one that has the sot-63 and now
Electronics Forum | Thu Sep 27 20:10:14 EDT 2007 | mika
Hi, There was a time not too long ago, when the discussion was about the possibility to post a picture or an image of let say a strange mis-placed part, to be able to fully describe the scenarios. In some cases It would have been grea
Electronics Forum | Wed Jan 23 05:50:35 EST 2008 | bentigano
Took about ten seconds for me, but still, 963kb's in .bmp format. Had you saved in .jpg format, it would have been 43kb. Either way, sweet feature. Unfortunately if people upload images nearly 1mb in size, I doubt the feature will stick around long.
Electronics Forum | Sat Jan 26 18:29:40 EST 2008 | mika
A picture with 1600 x 1200 pixels nearly 900KB! Well... I think SMTnet should maximize or standardize the pixel's or image size, like many newspaper do if you want to upload a picture... I rearranged this image to a 1/4 of its original size. Compare
Electronics Forum | Sun Feb 03 08:30:39 EST 2008 | davef
We dislike having to use the horizontal scroll bar [er whatever it's called] also. Large images in a posting cause the box used to reply to that posting to be shifted to the right is an nother peculiarity that could be improved. [Probably, this isn't
Electronics Forum | Thu Mar 06 09:19:53 EST 2008 | d0min0
Two way to check a HardDisk: 1. run a dedicated software check (each brand should have one soft) or run a test-benchmark that You can easily find on web 2. make "ghost" image of HD and then replace a HD with same size (GB) and put the image on new on
Electronics Forum | Tue Sep 09 19:35:26 EDT 2008 | vladig
OK. Here it goes. It's a series images taken after cross-sectionning one of the components. I hope that it's obvious now that teh "knob turning" technique wouldn't work that time around :-) I have one more image in my "back pocket", which explains
Electronics Forum | Tue Nov 04 12:58:17 EST 2008 | smt123
I have to agree with Patrick here. This image appears to show a board that is NOT HASL as there is what appears to be a copper pad in the upper portion of the image. But then again the arrow tip appears to be white and I woudl expect that to be red s
Electronics Forum | Fri Mar 26 15:17:30 EDT 2010 | jooh
Thanks for your replies! So what I understand is that ICT in reality is "only" a production process safety net, but it's a net that in most practical cases is needed. What ICT can not catch is (all) bad solder joints. What are the methods to find t
Electronics Forum | Thu Feb 24 23:11:51 EST 2011 | kemasta
HI I have this BGA short issue, I took x-ray image, the solder ball having big void. We suspect the pad on BGA was oxidie. Reject percentage quite low, only 5 out of 6000. But after the BGA re-ball, is work fine. Anyone have any idea to trobleshoot
