Electronics Forum | Fri Dec 12 17:19:08 EST 2003 | davef
Here's two angles to think about. Solder goes to the component and not both the board and the component because: * Component lead is much hotter than the the pad on the board. [This probably doesn't apply in your case, because it doesn't repeat fro
Electronics Forum | Thu Jun 01 21:59:10 EDT 2000 | Ray Chartrand
Does anyone know the current cost to repair a defective solder joint? I seem to recall a number quoted a few years ago of $1.03 per joint with burden of overhead. I've also seen numbers from 50 cents to 50 dollars per joint.
Electronics Forum | Wed Feb 15 15:39:38 EST 2006 | russ
Samir, how did you perform the Gage R&R on this equipment? What was your standard?
Electronics Forum | Tue Jun 06 11:57:12 EDT 2006 | Chunks
IPC 610 says acceptable Class 1 (Class 2, 3 indicator) if they are entrapped/encpsulated balls within 0.13mm of lands or pads. or exceed 0.13mm in diameter. Defect Class 1,2,3: Solder ball violates min electrical clearance. Solder balls not entrap
Electronics Forum | Tue Aug 27 03:45:36 EDT 2002 | seje
Hi there. We are considering to attach die chip with solder paste to the pcb at the SMD line (we are used to attach it with silver epoxy at the die bonding line before). This is a whole new method to me, so I'd like to have some opinions here. Where
Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,
Electronics Forum | Tue Jan 11 07:46:23 EST 2000 | Dave F
Wolfgang: Boy it's tough to convey context in this medium, isn't it? Clipped from our paste storage work instruction, environmental effects on paste are: 1a Avoid excessive heat (over 80� F). It causes flux separation, reducing print quality. 1b
Electronics Forum | Thu Jun 22 15:05:55 EDT 2017 | solderingpro
There are several different technologies in the industry today to assist in the out-gassing of flux cores. On automated soldering systems, there are two main types of perforating solder feeders: - Hole Drilling - "V" Scoring By perforating the so
Electronics Forum | Fri Apr 06 04:10:25 EDT 2001 | kensmoke
We recently had a multi block panal change at the vendor Now the production lines are producing solderability defects in great number. The makeup of the pcb is a type of fiber glass mask green in color and pads with no tinning just copper lands.
Electronics Forum | Tue Feb 07 11:38:50 EST 2006 | Chunks
Cal is right. SPC doesn't work at wave, period. Establishing parameters is very key for each product run. Then perhaps you can start grouping them. A WaveRider works well, but you have to use it everyday to make sure your parameters are correct.
