Electronics Forum | Sat Dec 30 19:02:19 EST 2006 | mika
This type of component packages works best with vision type: 254 - irregular. Measure the total package length including the leads. Also set the body dimension x-y tolerances to at least 0.35mm and the the pick up x-y tolerences to 0.5mm in the part
Electronics Forum | Sun Dec 31 10:27:39 EST 2006 | pima
Thanks Mika. I will have opportunity to check it out in New Year, because now we dont have production. So far we have beeen using vision type 11 and to be honest this type of defect, that placement of TNTA at flank side, happend very seldom. Usually
Electronics Forum | Mon Jan 15 09:19:29 EST 2007 | tk380514
We use Alpha EF-2202 low-VOC No-Clean flux Selective wave soldering cassettes Bottom pre-heating wave soldering machine We have one component that will not solder properly: http://www.epcos.com/web/generator/Web/Sections/ProductCatalog/Capacitors/Ul
Electronics Forum | Mon Mar 26 13:49:16 EDT 2007 | grantp
Hi, I don't know anyone who uses Mancorp, and apart from this forum have never heard of them. I guess the big problem I faced when getting into SMT is trying to find a machine that could do what we wanted at a good cost. I originally purchased MYD
Electronics Forum | Wed Mar 28 23:02:50 EDT 2007 | jmelson
If I couldn't afford to go to Boston to get some training from the seller, I certainly can't afford a week in Australia! But, thanks for the offer. I do have the HHK (hand held keypad, that's what Philips calls it.) And, after tinkering with var
Electronics Forum | Mon May 07 16:00:38 EDT 2007 | patrickbruneel
Dave, There is not really a �smart� or scientific way to check this but I know of easy ways and very effective ways. Fex. an easy way to check is with a 3� spatula, you hold the spatula at the same angle as the board and drag trough the wave simula
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Fri Jul 25 15:54:22 EDT 2008 | pcbbuilders
I am trying to optimize my reflow profile. i have a 5 zone oven. lead-free: for the 1st 3 zones, i am good, at about 150-200 deg for 150 seconds. during the 4th zone, i am at a temp of 200-220 for 50 seconds. during the 5th zone, i am at 220-245 f
Electronics Forum | Thu May 26 13:28:12 EDT 2011 | blnorman
I agree with Dave on the processing issues, but there are others: Print speed capability (do you get good deposits at various print speeds), humidity exposure (our plant did get to the high side so moisture absorption on the board/stencil was an issu
Electronics Forum | Tue Aug 30 11:13:23 EDT 2011 | markaustin
Hello Bill A colleague here at ACW just told me about your question and as we have a few of these machines I feel that I'm in a position to answer you. Prior to 2007 we only used DEK265 (GS & GSX) machines and these we getting a bit old and passed