Electronics Forum | Mon Dec 29 08:54:46 EST 2003 | pjc
SPM is superior. SPM has larger print area, up to 20� x 19", vs. 17.7� x 15.7� for the UltraPrint 100. UP100 is microprocessor controlled while the SPM has a PC. The SPM cameras can be positioned more rapidly and with greater accuracy than UP100's.
Electronics Forum | Fri Jan 16 07:06:47 EST 2004 | Mika
Component manufacturer often have recommendation for pad layout and process setup. This should be used as a guideline to help You to set up the process. Exactly what type of component is this, uBGA? We populate 64 I/O uBGA's on our pcb's with 0.3 mm
Electronics Forum | Wed Jan 28 08:11:20 EST 2004 | stefwitt
Martin, may I ask what your offer is? Does the pick and place machine vendor provide you with a special nozzle, which would not require the peel off cover. Custom nozzles from the OEM are quite expensive, because they implement engineering and test.
Electronics Forum | Thu Feb 05 08:27:58 EST 2004 | pjc
We had a V-Tek TM30 manual taping machine using heat seal top tape. Had very good results- with skilled operator - to supply taped components to our 2x Fuji IP2 machines - no tape cropping. Stefan's points are somewhat valid, but you can have a succe
Electronics Forum | Tue Feb 17 10:08:17 EST 2004 | russ
Do you have a bake oven that will reach 200C? You could bring a batch of boards up to temp and then start the pluckin'. A sfar as the solder goes if you apply flux to the leads they remove very clean as far as solder goes. To remove the flux we pl
Electronics Forum | Mon Mar 08 19:52:54 EST 2004 | Ken
I have processed the following materials in lead free processes: CEM FR1 FR4-120 FR4-140 FR4-170 Each material has different responses to thermal stresses. Issues to consider are: Panel size, smt only, wave only, double sided smt...and smt / wave
Electronics Forum | Sat Mar 20 08:37:06 EST 2004 | Primus
The BioAct SC-10 wipes work great, but I've noticed some contamination in our solder joints after I began using them on the stencils. After cleaning the paste off the stencil with the wipes, I started spraying the stencil down with isoproponal and bl
Electronics Forum | Fri Mar 05 08:47:32 EST 2004 | Ian White
Hi I work for tyco in Uk and have worked with Both 1030 and 1025 machines. The 1025 is the latest version of Mirae machines and the main diffeerence is that the machine is supplied with Linear Motors providing faster X,Y movement and more repeatable
Electronics Forum | Mon Mar 08 09:03:17 EST 2004 | russ
Is this problem really related to the size of the BGA OR the size/thickness of the PCB? Would I be correct in assuming that your pre-heater is small in size? Usually a board warps like this when the ramp is to great at the localized area. the imme
Electronics Forum | Mon Mar 08 04:52:25 EST 2004 | martin
Hello i have some problem with our dynapert. Wonder if you could give me some advise. The problem is our machine worked not so well so we started to take out one by one of the cards and check all ic's so they was properly inserted. But when we ca