Electronics Forum | Sun Oct 13 08:53:46 EDT 2002 | greenman
TI found an improvement in solderability on their Ni/Pd lead-finishes by using inert (nitrogen) reflow, but this is an expensive operation for just one part.
Electronics Forum | Wed Oct 02 12:12:24 EDT 2002 | angiewest
Our company is going to be using CIMBridge software for programming equipment and assembly instructions. Anyone using this software? Any questions I should ask before the trainer leaves?
Electronics Forum | Wed Oct 09 11:15:40 EDT 2002 | Randy V
Boothroyd and Dewhurst has DFA packages that are pretty good but are more for analyzing one design to an alternate design vs giving good times for your particular site, etc. You can find their site on the WEB.
Electronics Forum | Thu Oct 03 18:45:56 EDT 2002 | davef
Get started with an "On-Board Forum" [blue bar an inch down from the top of the page] moderated by Jeff Schake at DEK that was a discussion focused on stencil printing issues with 0201 technology. Chris: Are you putting 0201 on flex? If so, sounds
Electronics Forum | Sat Oct 12 05:05:09 EDT 2002 | Kenture
I run 0201 on a 5 mils stencil with openting of 15X12 and did not have any issue. The major concern is the placement and CP643 did very good job. Type 3 solder pastes was used. Good luck.
Electronics Forum | Fri Oct 04 14:11:14 EDT 2002 | franciscoioc
Does any one have a copy of the mpc-29 dehart printer drivers. We our hardrive crushed and we cannot recover this data and we don't have the driver discs
Electronics Forum | Fri Oct 04 16:17:50 EDT 2002 | ksfacinelli
I am interested in recommendations for International Purchasing Organizations (IPO's) that would help in sourcing. The agencies should be adept in electronics acquisition in the far east. Please send recommendations off list to: ksfacinelli@yahoo.
Electronics Forum | Tue Oct 08 03:57:16 EDT 2002 | rsasalm
Hi all, Sorry in advance if the question doestn't see to fit here. I am working on Siemens C167CS microprocessor and looking for a forum where I can send question relating to programming C167CS microprocessor. Thanks in advance regards rsasalm
Electronics Forum | Tue Oct 08 13:38:04 EDT 2002 | Peggy Strickland
I am in need of a manual for an SRT -1100 BGA repair machine. I have heard that SRT was bought out by another company. Does anybody know who bought them out and who might be the representative or salesperson in the Midwest area? Thanks! Peggy
Electronics Forum | Tue Oct 08 13:38:09 EDT 2002 | Peggy Strickland
I am in need of a manual for an SRT -1100 BGA repair machine. I have heard that SRT was bought out by another company. Does anybody know who bought them out and who might be the representative or salesperson in the Midwest area? Thanks! Peggy