Electronics Forum | Tue Mar 13 03:21:18 EDT 2018 | 3l3ctro
Do you also have some accessories that you use to keep your board level assemblies secured? I'm planning to buy some truck accessories (headache rack and chains) at http://4wheelonline.com to keep the boxes safe on the bed of my truck.
Electronics Forum | Wed Feb 21 08:35:15 EST 2018 | tsvetan
Depends a lot of PCB manufacturer and how good is the registration of the films to drills and what is drill precision etc. General rule is that components are placed on the copper layer pads, so copper fiducial is aligned with same accuracy as the pa
Electronics Forum | Thu Mar 08 09:41:23 EST 2018 | reckless
We currently contract our stuff out. I'm hoping to bring it back in. New machines are over $100k. If a used machine exists for $10-15k I'm open to it. I believe my job is simple other than 1 5mm QFN
Electronics Forum | Thu Mar 08 06:57:28 EST 2018 | davidportercpl
I'm struggling to place cylindrical components on the Panasonic AM100, melfs in particular. I have just about goet around the recognition side of things, but pickups are hit and miss, and placements are not very consistent at all. Currently using a 2
Electronics Forum | Thu Mar 08 15:04:20 EST 2018 | emeto
Both of these are very old platforms. I used them both in the past and they are both good machines. The question is how are you planning to keep them going? Spare parts availability? Knowledge to fix them? Calibrate them?Does manufacturer support the
Electronics Forum | Thu Mar 08 15:31:49 EST 2018 | jdengler
If you buy old equipment like these I would recommend buying from one of the companies that advertise here. Make sure it's one that has staff to support you. Some will say they have staff but they actually use contractors. That's not always bad bu
Electronics Forum | Fri Apr 06 06:01:06 EDT 2018 | reckless
Do you think this could be taught remotely through skype? I really don't have the budget for $10k in training but can afford $1k. We hope to sort out leveling, power, air issues ourselves. GSMs look highly complex. Is it possible they take much
Electronics Forum | Tue Mar 13 20:47:39 EDT 2018 | davef
I think of palladium coated copper with gold flash (CuPdAu) as bond wire used in chip attach. Look here: https://www.heraeus.com/media/media/het/doc_het/products_and_solutions_het_documents/bonding_wires_documents/fact_sheets/Factsheet_PdFlash.pdf
Electronics Forum | Mon Mar 26 02:48:29 EDT 2018 | cupet
Hi Sarason, Thanks a lot for Your reply. Now I find some manual for our secondhand machine. Now I try to program converter for preparing any csv file (for example P&P) to NCD file used for Marantz 22X software. You can find attached csv and ncd file
Electronics Forum | Tue Mar 27 09:19:13 EDT 2018 | robl
They used to be sold under the Samsung brand in our region, the old CP40's & 45's were good machines. I know people who ran them hard for many years with no issues. Haven't had as much experience with the SM*** machines, but people I rate like the