Electronics Forum | Thu Feb 17 02:49:04 EST 2000 | Roni Haviv
Hi, I need a wear resistance PCB finishing over bare copper (If exist!), the surface have a moving part which slides over it and bare copper as a surface is not good enough. I'll apprechiate any information. Thanks Roni
Electronics Forum | Thu Feb 17 01:58:29 EST 2000 | Roni Haviv
Hi Richard, You can use "MOLE" profiler, an accelent profiling tool. Good luck, Roni
Electronics Forum | Thu Feb 17 16:47:57 EST 2000 | Joe
80k at the time ('94). All 3 machines together were worth only about 90k. Obviously, we chose not to do the retrofit. If these are not the same machines, consider the above a lesson in dinosaur technology. Good Luck.
Electronics Forum | Mon Feb 14 12:31:54 EST 2000 | Dave F
Ed: Two things: 1 DeHaart: Lake Madsen Inc 12 Wilmington Rd Burlington, MA 01803 service and parts, Charlie @ (781) 270-3285 2 Buy a used EL20 for parts Good luck Dave F
Electronics Forum | Thu Feb 10 18:53:04 EST 2000 | Russ
It is okay to use OA flux if you have a very robust cleaning process. lots of water and saponafier are good things. No-Clean is much safer when it comes to reliability. I personally like the Indium no-clean products. Russ
Electronics Forum | Thu Jan 11 13:09:01 EST 2001 | Sergio Vito
Hello, I am locking forward spare parts for insertion machines. Someone have experienced good alternative suplies for mechanical parts to panasert and/or Mydata and/or Siemens machines Thank you very much Eng. S�rgio Vito Intelbras
Electronics Forum | Thu Jan 11 08:12:19 EST 2001 | Steve
We are trying to change to spray fluxing and it not going as good as I hoped, we are having more brigding then what we did with foam fluxing. We are using Qualatex 326
Electronics Forum | Fri Jan 05 07:19:12 EST 2001 | bing
I use this reference to check on SOT's. See if it any good for you. http://www.marsport.demon.co.uk/smd/smdcode.htm
Electronics Forum | Sat Dec 23 13:57:11 EST 2000 | Dason C
Keith, I try and the address is correct. Please check the link below again. Good luck & Merry X'mas. Dason
Electronics Forum | Thu Dec 14 19:54:23 EST 2000 | Dave F
SMT Magazine has "SMT In 10 Easy Steps or "Back To Basics" or something like that on their site that is a good starting point. If you want the one line definitions SMTnet has a "Terms & Definitions" in the "Library" You could ask us.