Electronics Forum | Fri Apr 10 10:31:47 EDT 2020 | proceng1
Certain customers do give us CAD. USUALLY ODB++ but I've also gotten .ipc and .pcb . Many of our customers bought or inherited a design, and therefore have no control to generate additional files. Or, as you mentioned, they had another manufacture
Electronics Forum | Wed Jul 08 23:07:18 EDT 2020 | tylerrobertson
Hello, Trying to re-purpose a QUAD feeder for delivering small parts to a scada robot. Wondering if someone could help me out with a pinout for the connector. it's 8 pins Feeder is p/n 12/10-23959B SSA Was able to get the board to power up and flas
Electronics Forum | Wed Jul 29 21:16:17 EDT 2020 | SMTA-64387706
Hi, I have a PCB that works fine when tested before conformal coating with HumiSeal 1B73. It seems like the CC is causing electrical issues. We brush it on, so it is a bit thick. After curing we are getting QFNs that do not seem to connect well and a
Electronics Forum | Fri Aug 28 17:24:28 EDT 2020 | stephendo
Did you check all the voltages and fuses? The second worst is when a machine is down for a while and it ends up being something basic. The worst is when it started as something basic and someone introduces a new problem. Also could there be any opti
Electronics Forum | Sat Sep 12 02:16:41 EDT 2020 | jmelson
Arrgh, that's an SFA-410ED camera, original subject was wrong. Hello, the down camera on my Quad QSA-30 has gone haywire. It still puts out video, but does not sync to the vision system, the picture rolls horizontally. I have verified the vision int
Electronics Forum | Mon Sep 14 21:31:33 EDT 2020 | dwl
Does the flickering go away once the oven reaches its set temperature? It will draw a lot more current while its warming up then when its running. Are your lights running on one leg of the same 415 VAC circuit? Reflow ovens are mostly resistive loa
Electronics Forum | Thu Sep 24 12:59:59 EDT 2020 | davef
If whatever is preventing the leads on your component from wetting is oxidation, cleaning the component will not help. Consider trying a more active flux prior to soldering. Understand from your supplier the potential complications that may affect
Electronics Forum | Fri Dec 11 17:39:42 EST 2020 | proceng1
Are you programming on the machine, or with a third-party software? I use Aegis CircuitCam to program my CS400s. I don't think I've done more than simple edits at the machine in 10 years. I don't know exactly what you mean by "permanent offsets",
Electronics Forum | Thu Dec 31 12:21:44 EST 2020 | ecogroup
I Changed old parts to New Parts for: All 5 Magnetic Contactors, Circuit Breaker/Protector 1, I/O Switch housing + contact blocks, both 12v and 110v relays. Still CP40 contactors won't engage after I/O Switch is pressed, G9D-301 Safety Relay Power Le
Electronics Forum | Thu Jan 07 14:11:08 EST 2021 | dontfeedphils
What is everyone using for assembled circuit board/finished good storage? I'm looking for ideas. Most of my assemblies will have some sort of wire pigtail soldered to one side of the PCBA, so they won't sit "flat", and I'll have a large enough vari
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400