Electronics Forum | Fri Feb 05 20:39:41 EST 2010 | localperm79
I've recently been placed in control of operations of our SCS conformal coat sprayer and I must eliminate problems with wicking of humiseal 1b73 into surface mount connectors while also trying to minimize masking as much as possible. We use a 55:45
Electronics Forum | Mon Feb 22 10:01:01 EST 2010 | jtsyeung
Since the inductor is electro-magnetic, that means the device is composite of coil and ferrite metal. The inductor inside the reflow oven meets with blower motors which close to the inductor and generate magnetic field. With such conditions, Lawren
Electronics Forum | Mon Feb 08 14:08:08 EST 2010 | sparky_
Greetings, We are looking to purchase equipment to rework / repair our circuit boards with BGAs. Our newer boards are starting to have more and more BGAs. Is there any information that "ranks" BGA rework stations? - a kind of a consumer reports for
Electronics Forum | Thu Feb 11 15:07:49 EST 2010 | hegemon
With regards to the rework, size and mass of the PCBs is important, in addition to the size of the components that are to be reworked. You might be in the game with $6K (APE Chipmaster Hot Air machine with Preheater or similar setup) if you have sma
Electronics Forum | Mon Feb 08 20:18:39 EST 2010 | city4497s
Hi I'm looking for a auto mold machine for PCBA application in singapore, anyone have any recommendation. My PCB size is 160mmX42mmX0.6mm, the units are arrange in array form and there are about 12 ~ 20 unit per strip. the mold size is about 15mmX5m
Electronics Forum | Tue Feb 09 09:18:13 EST 2010 | davemacnemo
Machine installer gave me some tips and a run through the software. Everything worked just fine. First solo attempt to run product that we started with gives L305 SoftLimitOver... error after picking first components and passing over camera. Additio
Electronics Forum | Tue Feb 09 16:04:06 EST 2010 | frankalbiter
Hi there, From the ISO 13485: 2003 std. standpoint, there is a special requirement which states: "The following requirements shall apply. d) If appropriate, special arrangements shall be established and documented for the control of contaminated or
Electronics Forum | Wed Feb 10 13:47:39 EST 2010 | davef
At a previous employer, we made a wearable medical device. When a customer finished using the device, she/he returned it to the company. Then, the company refurbished the device and rented it to other customers. Before it could be refurbished, it ne
Electronics Forum | Wed Feb 10 16:51:01 EST 2010 | flipit
Anyone using ENEPIG electroless nickel electroless palladium immersion gold? Am currently using selectively plated gold 25 micro inches in combo SMT/COB gold ball bonded product. Gold cost has increased over the years. Palladium cost is much lower
Electronics Forum | Tue Feb 23 12:49:10 EST 2010 | gregp
Dilbert is correct. The CS-400E machine is the machine of choice. The component insertions are light guided, the components are automatically presented to the operator and the leads are automatically cut and clinched at programmable lead length and