Electronics Forum | Sat Mar 02 18:02:26 EST 2013 | dilogic
Which vision does your machine have? I guess it is Lantern 630 or 640? Is there any text in the vision window after boot? regards Dejan
Electronics Forum | Wed Apr 03 03:41:00 EDT 2013 | ericrr
We used to use Butyl-glycol then I ran out and someone said it was no longer available. or maybe it was cheaper without it. After you use that you clean off the Butyl-glycol with IPA (Isopropyl alcohol)
Electronics Forum | Mon Mar 11 13:36:28 EDT 2013 | babe7362000
To get rid of the old info as far as the electrical test and so forth, just try to type in the pick number in CC, it should erase that extra info that you do not need. Do this after you uploaded your information. Hope this helps.
Electronics Forum | Tue Mar 12 22:30:58 EDT 2013 | ngineer
i can only see the issue after it's uploaded to the central controller. if the sequence is edited on the HHT, from V T Pick 9 to PICK 9, it stays that way until i download to CC and go to view it.
Electronics Forum | Fri Mar 22 12:57:30 EDT 2013 | bandjwet
Does anyone have any "tricks" for getting all of those little pieces of paper removed from the pad/ball side of a BGA after reballing. We are using the paper preforms and there are lots of those little preform remnants everywhere!
Electronics Forum | Fri Apr 19 01:46:20 EDT 2013 | dman97
This machine had been off for a few months. After we booted it a few days ago, this problem popped up. How exactly would I change the logic polarity?
Electronics Forum | Thu May 16 08:01:37 EDT 2013 | emeto
This might be a cable. It is not broken all the way - that's why you don't get the error all the time. After it moves for awhile it will break the connection and you start getting the error.
Electronics Forum | Mon May 27 07:16:27 EDT 2013 | mskler
We have an LED 0603 package, We are using stencil of 5 Mil, Before Reflow placement is perfact but after reflow it tis found that there is more than 30% LED are tilt. Can the speed of Fan in Reflow can help or I have to reduce the PAD opening in Sten
Electronics Forum | Mon Jun 17 06:56:50 EDT 2013 | bobpan
Did you teach the reject mark? Sounds like a lighting issue when looking for the white sticker. You can also skip images by pressing control-repeat after the machine has found fiducials. Good luck
Electronics Forum | Thu Nov 07 07:42:58 EST 2013 | sara_pcb
In continuation of the thread, attached 2d & 3d x-ray pictures of BGA after assembly. Kindly comment.regards, R.Saravanan