Electronics Forum | Mon Mar 05 22:33:31 EST 2012 | acsscott
We are trying to optimize it to pick up 8 components, then move over the camera, then to the PCB and place them. In the Mount data, we load heads 2, 4, 6, & 8 with a 3216 Resistor, then them next 4 components are LED's, and are loaded on heads 1, 3,
Electronics Forum | Tue Feb 21 16:38:18 EST 2012 | comatose
We finally can't avoid adding wave solder to our process anymore. For lead-free, medium sized wave I'm leaning towards mid 2000s senju units as the best fit. I've never run their equipment. Opinions? As a point of reference for our general capabilit
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Apr 19 16:08:36 EDT 2012 | rodrigo
Hi all, I'm still trying to get our CP4 to work. I've found 3 relays with bad contacts but replacing them didn't help (weird). I'm trying to check the input lines to the Direct I/O PLC. Could someone take a picture of the LEDs (IN1-3 and OUT1-3) aft
Electronics Forum | Tue Jul 17 15:26:08 EDT 2012 | kruzer
Hi I use CP4, CP6, CP643, GLV and NXT, but i have a problem with CPIV, i cant use It with Director Fuji Flexa. i use snifer rs232 (rs232mon) to resolve problem and what i know: Computer send on rs232 to machine (every 1 min or something): vQN2105
Electronics Forum | Wed Jul 18 14:35:56 EDT 2012 | kruzer
I can not send or receive proper of the machine, also i cant send or recive program. on the second computer I have, "ESMT 1.0.1," there without any problem computer communicates with the machine, but this is an old program and wants to have everythin
Electronics Forum | Thu Aug 02 12:47:15 EDT 2012 | deanm
Even though I cannot answer your question about a good Six Sigma training course, our company has had training in lean which I felt was helpful. You stated that one of your goals was to reduce cost/waste. That goal seems to lend better to a lean ma
Electronics Forum | Mon Aug 06 14:08:56 EDT 2012 | dyoungquist
We run a MY12 and our largest layout has 9700 components of which about 8500 (88%) are placed by the Hydra head. Average run time for our layout is 75 minutes. Based on that and depending on what percentage of your components are Hydra mountable, y
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
Electronics Forum | Mon Feb 04 22:39:51 EST 2013 | armandogomez
Ok we have to admit that for some reason you went for the used machine, but the $6000 are worth it, I have 2 of the same machine without the NG marker, and in 4 years (the newest one ) and like 6 o more of the old one, there have not been a mech prob