Electronics Forum | Wed May 25 06:31:46 EDT 2005 | ajaydoshi
We also want to use pallet method. How you work it out. We do have small PCB ( 30mm x 50 mm ) which have 0402 component & also micro BGA. Is it possible to make pallot for these component. thanks Ajay
Electronics Forum | Wed May 25 10:13:25 EDT 2005 | davef
Look here, while you're waiting for others to reply: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=33826
Electronics Forum | Wed May 25 12:29:39 EDT 2005 | chunks
Hi Dave, How/why is the 3M better? Sounds like you did some research and was wondering if reg. ol' hot melt might cause some other problems to the board. I bet the 3M costs a bit more too.
Electronics Forum | Wed May 25 13:56:45 EDT 2005 | jdumont
So it looks like 3M Jetmelt 3748 and 3779 would be suitable for what i need. Were either of these the ones you were refering to?
Electronics Forum | Wed May 25 18:27:06 EDT 2005 | russ
So what is happening to these nozzles? Are they sliding off of the compliance assy?, getting dinged? Have you contacted dynatech SMT about this yet?
Electronics Forum | Thu May 26 10:47:28 EDT 2005 | james
What is the highest temperature set at in your oven and your belt speed. Also what type of oven do you have? Thanks much. Your right about alot of heat needed. We actually see the outside balls much flatter and soldered compared to the middle bal
Electronics Forum | Wed May 25 21:56:06 EDT 2005 | dougt
I would think the communication between the machine and feeder would be the main drawback, not sure if the manufacturer will give you info on how they do this.
Electronics Forum | Fri May 27 08:55:45 EDT 2005 | cyber_wolf
Quick note on Hover Davis, I am not impressed with their Fuji IP feeders at all. They short out and blow IC's up in the MFU's They sell their own feeder set up stand to tell whether or not you have a shorted feeder. What the hell is up with that ?
Electronics Forum | Thu May 26 14:33:45 EDT 2005 | PeteP
CircuitCam offers great support, a superb product and CheckPoint can handle the Bill of Material comparison tasking you asked about. Friendly staff, good training and I do not receive endorsements $$$$. Just a good product.
Electronics Forum | Thu May 26 17:43:46 EDT 2005 | OverTheHill
Aegis, yup, very pricy. We just signed a PO for CircuitCam, CheckPoint and Fusion. Expect to have it up and running within a month. Sorry, no use info, but will keep you informed.