Electronics Forum | Wed Apr 21 07:32:04 EDT 2004 | podge
Hi, We have been using the Crest Solutions Reelscan system here for about 3 years on 8 lines and it has pretty much eliminated wrong part placement. We use it on a variety of SMT placement machines and i believe it can be adapted to any type of place
Electronics Forum | Tue Jun 15 07:52:45 EDT 2004 | chandramohan
There are many manufacturers, but if you think of a Indian manufacturer you can choose very good manual printer - Rollo from Synergytech Automation Pvt.Ltd. based in Pune. Rollo has all the features of semi-automatic stencil printer which i think ver
Electronics Forum | Sat May 08 02:46:23 EDT 2004 | Richard
This machine was working fine, now it come up with an emergency stop error "STOPPER", will not get past it, I have checked the board stoppers and all seem to be working correctly from the Manual IO. I did have to reload the 'proper' data, any body go
Electronics Forum | Fri May 21 09:24:00 EDT 2004 | stefwitt
I guess, you tried already to change the color to black. In-Out, is this a submenu for I/O, or do you find numbers in there from 0 to 244? If so, than this may be the color transformation menu. If you find two columns, then the higher number should b
Electronics Forum | Mon Aug 09 13:43:25 EDT 2004 | gbeck@optimumdesign.com
We just spent $100 and updated our Vitronics 800 oven software and it only shows only ONE zone for the entire machine. Vitronics wants $2,000 for a service call! Does anyone know what config file or software menu changes the number of software zones
Electronics Forum | Thu Oct 21 04:21:55 EDT 2004 | siverts
Have been through this before and we resolved our problem as follows: 1.Make sure that the length of your board support pins on Your HSP is correct. On that machine the board support pins depends on the board thickness (+ - some tenth's of a mm). It'
Electronics Forum | Mon Aug 16 13:31:45 EDT 2004 | Dreamsniper
We do not have problems with preheating. before we used to suspect that the cause of tombstone was that because the semi-auto and manual version do not have pre-heat stage. We had 1 with an IR heater and it is quite okay. you can use it too to cure a
Electronics Forum | Fri Sep 03 12:36:27 EDT 2004 | Frank R.
That's what I have ... two 5 zone reflow. A representative from AIM told me that 7 zone reflow is required with PbFree. It's good to know that it work fine with a 5 zones. Florida cirtech is the company who told me that SN100C do not damage your w
Electronics Forum | Thu Nov 18 11:47:17 EST 2004 | Nate
We currently redoing our floor layout and need to squash our SMT line into a smaller, rectangular cell. We currently use a manual printer/stenciler, pick and place, reflow oven, and aoi inspection machine. Can anyone give me any links to any differ
Electronics Forum | Wed Feb 09 14:48:30 EST 2005 | tinkergaloot
can anyone provide me with information on the operation of the Zevatech Print-MAT 220? Its a pretty basic machine, but my question relates directly to the squeegee blade setup and leveling the blades to the stencil. If you level the blades together