Electronics Forum | Thu Nov 14 10:24:53 EST 2013 | jaimebc
Recently, we have been experimenting with the 1.8/2.5 nozzle to be able to solder leads that are near an SMD. This pcbs were not design for selective solder, so we are trying to work within this limitations. I found the 1.8 nozzle very hard to insta
Electronics Forum | Fri Dec 10 12:55:36 EST 1999 | Larry Johnson
Marlies, I have never seen a nozzle on any SMT machine that does not require a vacuum. As for your first question, I believe them to be all one in the same. Larry Johnson
Electronics Forum | Fri Dec 10 13:33:55 EST 1999 | JAX
Marlies, Larry's correct. The terminology used to describe the nozzle is normally brought about by the methods at which the machines generate the "vacuum". Good job Larry, it's like you just won Fuji's WHIZ-QUIZ!! Have fun all!!!!!!!!!!!
Electronics Forum | Fri Dec 10 16:32:55 EST 1999 | John Thorup
well... it depends on what you are placing. Many odd-form placement machines, like Chad or Jot, use some sort of mechanical gripper as a "nozzle" without vacuum. John Thorup
Electronics Forum | Thu Feb 24 11:45:17 EST 2005 | JB
Any Universal GDM users out there, what nozzle type are you using succesfully to dispense glue on 0603's? Single or Dual tip? How about standoffs? Thanks in advance for the info.
Electronics Forum | Tue Mar 01 08:51:12 EST 2005 | JB
Bing, thanks for your reply. The nozzle that I will order needs to have standoffs, because we paste and then dispense glue (not my idea) So using the dimensions that you gave me I found the one that will work with our aplication. Thanks again for
Electronics Forum | Thu Jun 15 22:17:02 EDT 2006 | Thanagon
I'm now have target to flux saving. Could you please tell me. If we adjust level of spray fluxer nozzle up then we can saving cost of flux Quantity usage? What Others must adjust? such as pressure , flux flow. Thank you All for advise.
Electronics Forum | Sun Jun 18 21:41:58 EDT 2006 | Thanagon
Dear Sir, We used TAMURA type : TAF30-12DNS. This type nozzle can't moving up and down but we will modify that.Please comment that is O.K.? Regards, Thanagon
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Fri May 17 04:08:23 EDT 2013 | croma
I am interested about the most effective way to clean the Nozzle for Universal GSM machine and which fluid to use?
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
