Electronics Forum | Thu Aug 03 14:19:50 EDT 2017 | sumote
Looking at picture 20170801_095540.jpg, the leads look pretty long to me. This would cause you to have to lower your solder pot so that they don't get hung up. Have the leads cut to ~0.150" (0.200" max) long and then raise your pot up.
Electronics Forum | Sun Nov 27 05:04:02 EST 2016 | pmcg
Never used stainless pots as when we converted to lead free we changed all the pots to titanium. Been using SN100C for many years now, very good results, also use it in reel form in our selective solder machines with great results. Bear in mind the
Electronics Forum | Fri Jul 14 14:05:55 EDT 2006 | nodlac
Additional to Dave F.... A potato has Iron @ 2.75mg and Magnesium @ 55mg. The leaching of these two meatls could contaminate the solder pot and taint the solder. ----------------------- Additional to my additional..THE SOLDER POT POTATO BATTERY...A p
Electronics Forum | Mon Feb 04 14:42:08 EST 2008 | ratsalad
Are you talking about Durastone? That's what we use for our wave pallets. Both our wave vendor and solder bar vendor told us that we had nothing to worry about as far as Pb-contamination of the pallets. We have used the same pallets across our Sn
Electronics Forum | Wed Oct 07 11:38:17 EDT 2020 | rieko
We are draining a leaded solder pot. I'm sure these would work with leaded as well. those look beautiful!
Electronics Forum | Wed Oct 07 13:30:57 EDT 2020 | davef
I have great memories [bad dreams??] of draining solder pots. Previous discussions on SMTnet are worthy of review. Some are here: https://smtnet.com/index.cfm?fuseaction=search_submit&searchstring=bread+pan&collection=site_forum
Electronics Forum | Mon Aug 01 08:38:57 EDT 2005 | kamrant
Joseph, What is the topside temp reading of your board before reaching the pot? Do you have top-heater in your wave machine? It sounds like; you got an insufficient per-heating issue.
Electronics Forum | Mon Jun 05 18:50:10 EDT 2017 | caurbach
Hi Zac, My 2 cents: We had similar problems on a board in the same situation (tin-lead HASL, very long leads, low pot height, high pump RPM). Trimming the leads shorter, moving the pot closer to the board, and dropping the pump speed down to sane
Electronics Forum | Tue Dec 03 11:59:01 EST 2002 | slthomas
We haven't run a profile yet....probably because we're a-feared to. We can't do topside preheating here to any degree because we use an aluminum plate for aligning hundreds of top side through-hole components (pots, switches, buttons, LEDs) that te
Electronics Forum | Wed Nov 23 16:24:26 EST 2016 | misterblonde
Hello, I am new to this forum, and was hoping to get some advice/information from those of you that have switched your wave soldering machine to SN100C. I have read some old threads about people having great success with SN100C. My question is- w