Electronics Forum | Wed Apr 24 11:11:31 EDT 2002 | cnoonan
Sounds like your problem is your camera setting for Head 1 (Gain & Offset), are you rejecting any other parts on that head? Go to (Set) (Propers) (Cameras) (Gain & Offset) you can then zoom in and out to check light contrast. Check the numeric col
Electronics Forum | Tue May 14 14:02:13 EDT 2002 | Hussman69
It all depends on the part you're cooking. Most components have a storage recommendation in their spec sheet. So be sure not to exceed it. Generally I see a lot of spec sheets that are arounf 140 C. So I set the oven for about 100 C and let it go
Electronics Forum | Fri May 17 08:12:37 EDT 2002 | danial
I'm trying to convince my customer to change to the clean process. They are asking me what is the benefit of going to clean process from no-clean. does anybody have any input or reference/article that I could refer to include in my report ? Apprecia
Electronics Forum | Wed May 22 09:59:52 EDT 2002 | stefwitt
I don't know how much Siemens charges for this option, but I guess we both know what a new head costs. Siemens did let go on more service techs. last weekend. They all can install this option for less than Siemens quoted. If you can't find a tech. in
Electronics Forum | Thu Jun 06 13:17:33 EDT 2002 | Hussman69
Don't forget squeegee type and angle. (Am I an Ian wanna be or what?) I'd leave out different types of solder paste. For measurement, use something like a Cyber Centry. It may cost a little, but if you're serious, it's worth it. Other wise you m
Electronics Forum | Thu Jun 06 03:49:50 EDT 2002 | ianchan
Sam : Hi, goto "www.yahoo.com", under yahoo search option and literal type the following sentence: "AXI" and "AOI" and "Agilent" click "go" button, search engine will generate lotsa crap, some of it will be what you want. Agilent is marketing it
Electronics Forum | Tue Jun 11 06:43:28 EDT 2002 | pjc
If your goal is to inspect solder joints then X-ray is the way to go. AOI is not effective at solder joint and is best at component inspection. Using an AXI or AOI for solder joint inspection requires a lot of engineering time. Don't know any good si
Electronics Forum | Tue Jun 11 10:59:08 EDT 2002 | jseagle
Thanks Dave. My engineers are not going to like the news but it's good for me. Maybe now they will use 0603s instead of the 0402s which are not required due to plenty of board space being available. They want to do 0402s just because we now have a
Electronics Forum | Thu Jun 13 15:43:19 EDT 2002 | mjabure
The major draw at NEPCON was the the machine manufacturers. With most of the big players going to the APEX shows, NEPCON attendance has seemed to slow down quite a bit. Although APEX wasn't very busy either. With the industry in it's current state no
Electronics Forum | Thu Jun 20 16:24:59 EDT 2002 | blnorman
At the OSHA training institute, our instructor stuck an electric drill in a bucket of water to demonstrate what proper grounding will do. Personally I wasn't going to try it. All our fluxes are no-clean, and are IPA based. Granted we used aqueous