Electronics Forum | Tue Jan 23 23:28:54 EST 2007 | jovial_guy23
If you have flux deposits on the cooling plates, try out Zestron's VIGON RC101...It is an extremely good product especially for reflow ovens and wave solder systems. Check it out...Minimal maintenance water based chemistry with no flash point...Much
Electronics Forum | Thu Jan 25 16:54:30 EST 2007 | Frank
I heard the same rumors about why they were kicked out of Anaheim: the hotels complaining not enough rooms were being rented and the center complaining that they loose 2 weekends for a 3-day mid-week show. But that is no excuse to put it in LA. S
Electronics Forum | Thu Mar 01 18:46:05 EST 2007 | fastek
I'm having a difficult time understanding the need anymore for a West Coast show going forward. Other than tradition, let's face it.....there is much more going on in the midwest these days. All and all....I don't see much of a future in Southern C
Electronics Forum | Thu Jan 18 17:08:28 EST 2007 | jaimebc
Production reject IC short? So there is a solderbridge on your IC? What type of IC? A few things to consider: 1.- Too much paste during screen printing because you may not have enough PCB support You need to provide as much details as possible (
Electronics Forum | Fri Jan 19 10:18:44 EST 2007 | Simon C
Hi, We have at DEK printed paste through a Pumprint stencil onto clinched leads, but there will be limitations depending on the product. If you can send a sample loaded board to me indicating where you want paste deposits then I can certainly take a
Electronics Forum | Sun Jan 21 13:36:31 EST 2007 | jgarver1
Bert, Sounds like the CPU in your IP 1 needs replaced. I have seen the exact same issue a few times over the years. Only fix I came up with was replacing the CPU. Contact me if you would like to buy a functional used replacement. Thanks, Jared
Electronics Forum | Mon Jan 22 09:35:34 EST 2007 | saaitk
Check that your boards haven't been over plated. Too much plating in the hole can slump to the underside of the board during reflow. If you are then press fitting on the underside of the board you can have problems with hole diameter. If the hole is
Electronics Forum | Wed Jan 24 09:52:50 EST 2007 | electronhose
Sounds like you need a support pallet to accommodate the narrow side clearance. Several pallet houses made pallets that work in screen printing that have flush board edge clamps that hold the board in the pallet yet allow the stencil to come all the
Electronics Forum | Tue Jan 23 14:09:11 EST 2007 | behrsam
We have been struggling to create an improved higher yield process for hermetically soldering a metalized Ge window to Kovar. Process utilizes flux with a Indium alloy solder preform. End use is for a dewar package. We are looking for a consultant
Electronics Forum | Tue Jan 23 17:16:07 EST 2007 | darby
Check out the web sites of the major solder manufacturers. From a quick glance most of the pastes around that temperature range have problems with Zn content and may not be available as pastes???? Depending on your application, some of the lower melt