Electronics Forum | Wed Mar 03 04:26:58 EST 2004 | Evtimov
Hi Chris, About marks detect: If you have vision system you can recognize the fids and not center them manual. If only camera you have to put the center of the camera in the center of the mark.
Electronics Forum | Thu Mar 04 19:30:11 EST 2004 | russ
I don't have a clue, but I am really curious as to the purpose of this thread. Did you have some boards come out of an oven that were vaporized and you are curous how hot they got!! OR are you trying to "go lead free" just kidding. Russ
Electronics Forum | Tue Mar 09 09:52:59 EST 2004 | danhui888
Use ECD Xpert Ready system. This unit will helos you to predict and recommend you a correct profile. This will helps you to reduce downtime and improve your process too.
Electronics Forum | Thu Apr 01 08:44:58 EST 2004 | pjc
Be smart, be skeptical and be educated on the machines you are looking at. If you are going to do business with someone you don�t know, check them out. Ask others in your region and get at least ten customer references from them.
Electronics Forum | Mon Apr 19 14:13:12 EDT 2004 | selsold1
Dreamsniper, What type of flux are you running? This will have a big impact on the profile you choose. What parts are you soldering and how many layers is the board? selsold1
Electronics Forum | Thu Apr 22 14:31:03 EDT 2004 | northern
I have used both the MPM and DEK. The MPM's look nicer and have a few fancy features but the DEK printed more consistent time and time again. I believe you spend a lot more money for MPM's when DEK will give you what you need.
Electronics Forum | Thu Apr 29 07:21:00 EDT 2004 | Claude_Couture
Depends how much money you have in your budget. You have to break down your assembly into the different components and figure out what can be done by machine and what can't. Then search for machine that can do the jobs. There are consultant firms tha
Electronics Forum | Wed May 05 01:44:56 EDT 2004 | fastek
Sam- MPM USA won't help you on this unless you have registered the machine with them. Contact the China support guys and they will probably help you out.
Electronics Forum | Fri Jun 04 10:19:30 EDT 2004 | gregf912
Your autmated system fired back to me that you have been bombarded with mail on this subject. I am sure you have. You can get my address by going to my website at WWW.ATS-SMT.COM from there we can discuss the issue in more detail.
Electronics Forum | Sun Jun 13 07:48:18 EDT 2004 | Grant
Hi, Thanks for the info, and can you provide a little more info on some of the reasons you think the Fuji is better than Universal. For example, can you explain some of the advantages and disadvantages etc? That would be really helpful! Regards,
