Electronics Forum | Wed Sep 06 14:41:02 EDT 2017 | tombstonesmt
You need to slow down the machine for starters. Try rotating your nozzle so that the touches the least amount of silicone membrane as possible.
Electronics Forum | Thu Apr 19 01:50:49 EDT 2018 | leeg
Whats the best way to joint a broken conveyor drive belt? Ive tried a rubber glue which lasts for a short time and tried touching both sides to an iron tip and then holding together, again with poor results.
Electronics Forum | Mon Jan 28 07:37:23 EST 2019 | babe7362000
You could also try swapping the motion cards. X and Y are swappable I believe. And see if the problem goes to the X. I have had to do that in the past for troubleshooting. It has been awhile since I have touched a IVC, but I loved those machines.
Electronics Forum | Tue Feb 19 13:31:28 EST 2019 | SMTA-Joe
I have seen this issue with manufacturer markings stamped on PCBs. The ink just melts away as soon as CC touches it.
Electronics Forum | Sun Mar 31 23:09:58 EDT 2019 | dekhead
ProFlow runs on standard software on Typhoon (Horizon/Infinity) printers. I won't make the "Is it worth it?" call as I have customers who swear by it, and some who wouldn't touch it again. Small % (
Electronics Forum | Wed Jun 26 19:42:44 EDT 2019 | bane016
Have some option to fix it by glue with dispenser? Did you check mby that component touch something inside oven?
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Thu May 21 15:43:18 EDT 2020 | ccouture
That brings me back, I haven't touched one of those in 15 years. But If I remember right, some of the control cards have rechargeable coin cell on board and they might be weak. Do you have access to Panasonic support?
Electronics Forum | Wed Apr 06 11:17:02 EDT 2022 | proceng1
Because it was recommended by the machine manufacturer. Sup 75 is also very corrosive. It basically ruins any tools that touch it if they aren't cleaned properly. I am ordering some of that powder to try.
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the