| https://unisoft-cim.com/assembly-instructions-documents-substeps.html
. In the figure above is another example of a use for Substep. For instance, if the PCB was being assembled in a slide line and one of the part numbers being assembled had a large quantity of components and you wanted to distribute that among the slide line
FKN Systek | https://fknsystek.com/PCB%20Racks.htm
Hot List for PCB Storage Transport and storage for work in process A variety of PCB Racks are available for handling assembled printed circuit cards during the manufacturing process
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/industrial-coating-systems/products/spray-systems/trilogy-non-electrostatic-air-assist-airless-dolly-systems
. Available to order as one-part number dolly systems Dolly, heater, pump and gun are pre-assembled to eliminate component assembly Available in a variety of configurations for added versatility
Imagineering, Inc. | https://www.pcbnet.com/support/faqs/
? A BOM is a Bill of Materials that list the components required to build your project. BOM’s include Part Number, reference designators, quantity, and description of parts that need to be assembled
| https://www.wesource.com/test-and-measurement-equipment/ets-lindgren-model-16-2/2.-0-rf-enclosure-10x7x8-id-140035/
: There will be an additional $500 charge for the custom built skid(that was our cost) Assembled picture is for reference only. Asset# 140035/BA Products You May Like Dynamic Solutions MicroVib II 1300 Aircraft Analyzer ID_53953
54386 | https://bajabid.com/wp-content/uploads/2022/08/Glenbrook-RTX-113-Brochure.pdf
Baja Bid
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-stranded-wire
3.3 Flux, stating within the paragraph that “… Type H or M fluxes shall not [D1, D2, D3] be used for tinning of stranded wires.” Once the wires are tinned and assembled to their respective terminations, be it either a terminal, or a printed circuit board, other approved fluxes can be used to make those connections
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/de-DE/divisions/dage/woerkzeage-and-materialian/acota-certonal
. The boards are immersed in the fluid and then transferred to a drying zone. After a short drying time of 2-5 min. the assembled coated boards can be transferred to the next process
KingFei SMT Tech | http://www.smtspare-parts.com/buy-surface_mount_parts-page26.html
:59 K9F4G08U0D-SIB0 Samsung Chip Component Assembled SMT Machine Parts Contact Now K9F4G08U0D-SIB0 Samsung Chip Component Assembled Detail Information: 1, Part Name
KingFei SMT Tech | http://www.smtspare-parts.com/buy-smt_assembly_machine-page11.html
:35 K9F4G08U0D-SIB0 Samsung Chip Component Assembled SMT Machine Parts Contact Now K9F4G08U0D-SIB0 Samsung Chip Component Assembled Detail Information: 1, Part Name