Electronics Forum | Thu Feb 21 06:31:20 EST 2008 | gregoryyork
We treat all our alloys with measured Phos additions. SAC alloys treated with Phos WILL/DO dross approximately half the amount of 63/37. Most Solder companies will not tell you this as they wish you to use more Solder. We are a Nitrogen Cast Solder p
Electronics Forum | Thu Apr 15 10:09:55 EDT 2010 | davef
Dross formation rates for SnCu and SAC are roughly 2.5 times the rate for SnPb (Hwang et al., 2004) Methods for reducing dross are: * Lower pot temperature * Run pump speed slower and only when soldering * Check solder contaminants to BS219, ASTM
Electronics Forum | Wed Mar 28 05:15:33 EDT 2018 | reckless
There is no local support for Juki or Samsung in Chicago. If I pay $5000 Samsung will be able to monitor everything remotely. I am still unsure of the life of a pick and place machine. I have seen some Universals get to 50,000. Not sure about Ju
Electronics Forum | Fri Dec 01 12:02:15 EST 2000 | blnorman
I have over 10 years experience in aerospace materials, part of which was involved with vacuum casting inert propellant formulations. These propellants are in the range of 80 - 90% solids loaded with viscosities of 15 kP. I'm not sure where I could
Electronics Forum | Tue Nov 21 16:58:20 EST 2000 | blnorman
Does anyone have any experience with solder paste recovery? Specifically, partially emptied solder paste tubes. We are currently looking into ways to reduce and potentially eliminate solder paste waste. One of the largest contributors is partially
Electronics Forum | Thu May 03 18:13:40 EDT 2001 | johnthor
what are these kids doing in the dark with band-aids anyway? I'll bet you could get the same effect with Kapton tape (maybe yellow light?) Seriously, I use the IIT proframe Dave mentions down to 25 mil but have gone back to a permanently mounted foil
Electronics Forum | Mon Mar 15 15:47:51 EST 1999 | Steve Schrader
| Are stencils universal from one printer to another? We are looking into the possibility of going from Solderprint 1414 manual printer to a more automated printer. We are also considering bringing some boards we currently outsource in house. I w
Electronics Forum | Wed Nov 21 05:21:39 EST 2001 | frha
Thanks Dave! I agree 100% with you and try not to deceive myself! It is very dangerus to let it be a dam paperwork of must. Good id� to change focus frpm process to product-characteristics!! I will see the benefits and cost savings as well as the t
Electronics Forum | Sat Oct 12 06:46:17 EDT 2002 | davef
You say "I have seen you make false accusations of name changing and false postings against some reps quite irresponsibly. In conversations before with others offline your accusations have forced a number of good reps to skip providing input simply b
Electronics Forum | Thu Jul 17 17:39:08 EDT 2003 | slthomas
If you wanted to use ultrasonics to wash an customer's assembly, and you'd had poor success doing it in the past, would you consider it reasonable for the customer to request that YOU provide cross-sectional image analysis of the first batch of new p