Electronics Forum | Thu Mar 18 09:25:27 EST 2004 | remullis
Normally when I run into having to hit the ESC key to step through this is the steps I take. 1. Power machine down and restart. 2. Home machine and watch cutter carefully. Both cutter should acuate and the height motors should run CW and CCW. 3. You
Electronics Forum | Fri Nov 12 15:56:50 EST 2004 | pdeuel
Thanks, That's the direction i'm headed. After by passing relay altogeather, testing large caps for the driver supply, replacing bridge rectifiers, and the MOV's, that's about all im left with. The vacuum motor will run with the software toggle witho
Electronics Forum | Wed Dec 06 11:16:06 EST 2006 | Todd
Ok, an update... I finally found my 24Vdc. I was trying to use a screw and/or outside of the connector for ground. It was necessary to use the ground IN the connector pins. I believe it was the top/right and 3 o'clock pins that toggled with the 24Vdc
Electronics Forum | Fri May 14 09:34:18 EDT 2010 | lockj69w
This procedure is from UIC's knowledge base. TO run Diagnostics on AISI 3500 vision. Use of this procedure will require reloading of vision executive once complete. 1. verify PC1 COMM2 is connected to COMM2 on the RADISYS board in slot 1 of VME chass
Electronics Forum | Mon Sep 02 15:41:47 EDT 2013 | aemery
Mr Duckmann2000. Where is the leak??? Is it up on the dispenser behind the printhead? If so the simpliest thing to do, assuming you are not using the dispenser, is to cut the incoiming air tubing to the dispense pinch, fold it over and ty-wrap it.
Electronics Forum | Mon Dec 30 21:38:56 EST 2013 | jkoughan
I've got a scary one for you guys and desperately need your help - We just purchased a second Quad 4C and had some communication problems when we first turned it on (we're still working on that issue). To chase down the problem, we decided to start
Electronics Forum | Thu Mar 29 20:15:41 EDT 2007 | darby
PCB > Origin > Origin 0 4 Teach the corner of the pcb at the mechanical stop. This data is from the machine origin. For a unit with a teach camera it will probably be around -25x, 95y. For a beam sensor around 70x, 28y. This is for a right to left
Electronics Forum | Sat Mar 31 11:03:21 EDT 2007 | jmelson
I have a left to right conveyor, so the X offset is larger, but that is not major. You say "Make sure you are teaching with the unit that the machine defaults to or asks for." This is the beam sensor, and I have found no way to change this, either
Electronics Forum | Wed Sep 18 18:40:05 EDT 2002 | dougt
Here is how smema works: Machine A has a board to give to machine B. Machine A has an opto or a relay that will turn on or close when it is ready to pass this board to machine B. This is the "board available from previous" signal, telling machine B
Electronics Forum | Mon May 02 12:35:33 EDT 2016 | adamjs
Or try : http://www.sipad.com/ I think sipad is incredibly cool and would be the perfect solution, but is way too expensive. We're paying $0.80/each for four-layer ENIG boards, 50cm^2 with 0.125mm trace/space and 0.8mm-pitch LGA landings in lots of
