Electronics Forum | Tue Oct 03 15:28:24 EDT 2006 | realchunks
No adhesive? Then how about 2 different solder pastes? Higher melting temp for the first side, lower for the second.
Electronics Forum | Mon Oct 02 05:51:46 EDT 2006 | dave
All, What controls do you have in place for PCB moisture control? If you had a kit of 400 and you ran out of a part which wasnot due in until 6 weeks- do you store the boards in a dry cabinet ? Vacuum seal and store on a rack? Alan...
Electronics Forum | Wed Oct 04 11:39:26 EDT 2006 | SteveH
Thanks Dave. We are UK based which is why we are still allowed to use Trike and our product is for an aerospace application so changing a cleaning chemical is much easier than requalifying a new flux. This was pretty much what I thought my options
Electronics Forum | Mon Oct 02 14:59:29 EDT 2006 | jbecircuits
Ooops sorry! Has anyone ever had a problem with using FR4 for a burn-in board? We suggested using Nelco or getek, but will FR4 have any problems in the assembly area through the solder wave?
Electronics Forum | Mon Oct 02 17:33:24 EDT 2006 | russ
nope it will not, I am sure that an FR-4 board has been wave soldered sometime in history Russ
Electronics Forum | Mon Oct 02 17:00:13 EDT 2006 | Chris G.
Does anyone have a motor frequency inverter(driver) for an ERSA Versaflow, that you can sell me? It says "Seidel" and then "digifas 7200". I know this is a long shot, but even if it's used I'll take it.
Electronics Forum | Mon Oct 09 09:34:51 EDT 2006 | C.K. the Flip
Funny that you post this, but I just had one of these go bad on me. ERSA Field Service came in and replaced it.
Electronics Forum | Tue Oct 03 09:36:30 EDT 2006 | Brian
Using a meter to check a BGA connection to the board, there will be other parts of the circuit involved. Sounds like a bad batch of parts.
Electronics Forum | Tue Oct 03 15:03:57 EDT 2006 | cyber_wolf
We have not had very much luck hand dispensing on small pads. It can be done but you will most likely have bridging and insufficients.
Electronics Forum | Tue Oct 03 15:18:27 EDT 2006 | Steve
If it's only 30 boards why not just get a stencil foil and hand print it? It's a piece of cake...