Electronics Forum | Tue Apr 25 17:09:02 EDT 2017 | tomwd
Is the computer PSU located in BM4CB unit and get the 12v/5v voltages generated from 12v/5v box via the XP5/12v cable?
Electronics Forum | Tue May 02 22:04:54 EDT 2017 | ttheis
Have you reviewed the wiring diagrams and checked voltages at the input card? Maybe you have a damaged IO card or broken cable.
Electronics Forum | Tue Dec 05 02:15:12 EST 2017 | bukas
is that the only motor with that function or there are others? if you have more than one motor try switching cables and/or drivers and see what happens. this kind of behavior can also be caused by stepper driver.
Electronics Forum | Tue Jan 09 15:26:49 EST 2018 | emeto
The truth is that TH will give you better mechanical stability. If it is a part where you risk strip off the pads of SMT connector, don't make this transition to SMT. If it is a one time cable plug there and there will be not too much pressure, go fo
Electronics Forum | Mon Mar 05 11:12:13 EST 2018 | assuredtech
Without a known good Executive and a known good battery and a known good Comm cable, card swapping / exchange is probably not going to be helpful yet. I might have an Executive you can try, I'll try sending you an e-mail.
Electronics Forum | Thu May 17 06:46:39 EDT 2018 | godless
After fresh install and loading only machinekey + stdeaf files it worked, thanks. But still there is camera problem which appeared from the beginning. I attached files where you can see error details. Software reinstallation not solved issue. Then ca
Electronics Forum | Mon Jul 30 17:31:59 EDT 2018 | dekhead
That error message is keyed by a hardware (soldered) link on the backplane board of the Y1 (motor controls), through direct cable to PCIB40#3... check connections both ehds; possibility of multiple PCIB failures?
Electronics Forum | Tue Jul 31 17:24:33 EDT 2018 | erici
There is a hardware dongle at the back of the machine. Is this the hardware link (key) you are referring to? Ok i will check the cables to PCIB40#3. Thanks again
Electronics Forum | Wed Aug 01 09:03:54 EDT 2018 | bukas
check 12PL14, 12PL16, 12PL17 connectors. also, there are few jumpers on backplane of Y1, check them too. a single broken wire can get you this error, so my bet is cables.
Electronics Forum | Thu Aug 02 16:47:37 EDT 2018 | erici
Thanks for all your help guys. The problem ended up with the parallel port where the hardware key(dongle) was attached. The cabling from the pc to the parallel port at the back of the machine was defective. Cheers
